Top 20 2006 Mitsubishi Outlander - Page 5 Questions & Answers

Follow the link for full instructions. Repair Guides Radiator Removal Installation AutoZone com

use a scan tool

It needs to be pushed forward to release it from the join

https://www.youtube.com/watch?v=EuintjJ05iA

I believe they don't have one

Your Radio went bad. Happened to my Honda Radio when it was 6 years old.....

where is the adjuster on a 2005 mitsubishi outlander

It sounds like one of your CV (constant-velocity) joints is going bad. This is common on front wheel drive vehicles. The CV joint allows the drive axle to pivot as you turn the wheels. Over time the protective boots crack, the grease leaks out and you end up with the knocking noise you describe when turning while accelerating. The dealership should easily be able to inspect the CV joint boot and diagnose the CV joint.

you need to have the ecu read abs fault can lead to engine not starting.as signel from abs is not getting to the ecu.

reley needed mite be

check your oil...

it is worht checking the fuses and also keep working the hazard light switch as they are not used that often they tend to get sticky on the con tacts and that will knock out your indicators as well if they start to work after working afer working the haz switck then change the switch

Probably. Cheap place to start.

check the remote battary if not good change and check the signal to unit olso

I would check the inside of your oil cap. if it has a white or milky residue texture you have a blown head gasket or head. have that checked. good luck

While driving, slightly turn the wheel left and right, to see if the noise gets louder and quieter. If it does, you have a wheel bearing that is failing. Then you need to isolate which side is making noise and have it replaced. SOON

might be your lifters, or a bad connecting rod bearing

not as such but the CPU will put it in limp mode which is reduced power and speed

You have to let it set for around an hour with engine off and key in the on position to get it back to code then you will need the serial number off the top of the radio and call a mitsu dealer n they will give you your correct code

check coolant level, and for leaks, check for cooling fan operation, if those are good and working, possibly blockage in radiator or thermostat problem