20 Most Recent
2005 Mitsubishi Endeavor - Page 4 Questions & Answers
Starter
Here's a
link to your starter,follow positive battery cable.
P0108
Code 108 is for a problem with the map sensor that measures engine vac.The sensor would need to be tested.
My rear hatch and glass hatch will not open from the outside.
This is extremely common!
The micro-switch inside the glass hatch release is faulty, telling the door that it is partially depressed, thus shutting down opening for safety reasons.
You can verify this by opening the glass hatch (there is a access panel at the bottom of the door on the inside), removing the trim cover from behind the glass handle (two philips screws and one plastic push in fastener), then unplugging the glass handle.
Your door will now function normally, but without glass opening ability until you replace the handle.
The handle only takes a few 10mm nuts to remove and can be changed in a few minutes. It retails for around $35 from your dealer.
Sputtering
have it checked for free at most autoparts stores. They will give you one or more "Pxxxx" codes. That code is the key to the problem. They most often offer you the part to fix it.They do not reset the engine light for you, but if the part/s were replaced, you can either disconnect the battery for 10 minutes to reset it, or in many cases, just drive around like normal, and after the computer knows there is no problem anymore, it will go off.
Not finding what you are looking for?