20 Most Recent 2003 Mitsubishi Galant - Page 7 Questions & Answers

0helpful
1answer

Engine starts then die when idling, changed fuel pump and also magnets (COILS)

I had the exact same problem with my 2003 Galant. The above solutions may be correct but try some other things first. 1) start car and with engine idling turn on the AC. If the rpm's drop and don't come back up or the car dies, it is probably a dirty max air flow sensor. This is an easy fix even for a novice. Many you tube videos to show you how to clean. 2)check spark plug wires and boots. Cheap solution and a likely culprit. 3)Is your service engine soon light on? Could be an emissions problem. If you are able to drive the vehicle and notice that even at highway speeds you slow down with pressure on the accelerator you may have to replace something in secondary emissions control. Not likely. If it is a vac. hose leak you should be able to hear it and locate it with your hood up and engine running.
3/11/2014 3:30:47 AM • 2003 Mitsubishi... • Answered on Mar 11, 2014
0helpful
1answer

Fuel cut off valve fault galant ..... car starting but loosing all power on acrelaltion and switching off

Only on a Ford & only in case of an accident Fuel Safety Shut Off Switch is either open or closed Knowing that & the fact you had no accident to open it, you move on & check fuel pressure
2/28/2014 11:27:33 PM • 2003 Mitsubishi... • Answered on Feb 28, 2014
0helpful
2answers

Galant rear wheel hub

remove your rear wheel then remove the brake assembly. there are 4 bolts that hold the hub to the rear axel with anti lock brakes you will have a wire to remove from the hub. it may tak a large hammer and chisel to remove the hub. but it will come off. then reinstall (if there is any shims behind the hub they must be put back in in the same directions (these are alignment shims) some have some dont. tighten bolts and test drive the ca 5 miles or so. then retighten the lug bolts. and then again after 100 miles.
hope this helps 99116a8.jpg
1/31/2014 8:46:12 PM • 2003 Mitsubishi... • Answered on Jan 31, 2014
0answers
0answers

P0102

Be the first to answer 1/17/2014 3:16:20 AM • 2003 Mitsubishi... • Posted on Jan 17, 2014Be the first to answer
0helpful
1answer

My car cranks but wont start hooked up scan tool but it seem to be communicating with the PCM what tests should i perform next

Use a bottle of yellow HEET dry gas to remove any moisture problem in the fuel. Clean / replace air filter. Top off ATF to MAX level. Use starting fluid to aid starting.
1/16/2014 11:37:00 PM • 2003 Mitsubishi... • Answered on Jan 16, 2014
0helpful
2answers

Car cranks but wont start

*Check for these things: -Fuel, spark,Crank/cam sensor, temperature sensor. Good luck Mai
1/16/2014 11:10:13 PM • 2003 Mitsubishi... • Answered on Jan 16, 2014
0helpful
1answer

Schematic of gearbox mitsubishi magna 2002google

over filling the oil in transmission is just as bad as no oil. Drain to correct oil levels.
1/5/2014 10:46:03 AM • 2003 Mitsubishi... • Answered on Jan 05, 2014
0helpful
1answer

Transmission

Sounds like your gear box or clutch is going. Might need to get it looked at, yes it can effect certain gears only.
1/4/2014 4:12:19 PM • 2003 Mitsubishi... • Answered on Jan 04, 2014
Not finding what you are looking for?
2003 Mitsubishi Galant Logo

1,152 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Mitsubishi Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Galant Mitsubishi

  • Galant Mitsubishi

Most Popular Question

2003 mitsubishi galant 2 4 engie runs

  • Cars & Trucks
Loading...