20 Most Recent
2002 Oldsmobile Silhouette - Page 5 Questions & Answers
Heater blows cool warm air idiot light says it is hot
Engine temperature is too hot. Better not run it till you find the problem, or you may need new head gaskets. Try changing thermostats, flush and refill with correct mixture antifreeze and water. If still overheating, get it to a shop for diagnosing.
Loud clank right front when turning
ball joints, tie rod ends, faulty rack n pinion, control arm bushings, sway bar end links, or you just could be hitting the steering bumpstops.
My 2002 olds silhouette had a fault code for bank
Bank 1 sensors are all the o2 sensors before the converter. Bank 2 sensors are all after the converter.On bank 1 there is 1 for each side of the exhaust manifolds. Bank 1 sensor 1 is on the side ot the engine that #1 cylinder is on. Bank 1 sensor 2 is on the other side. On front wheel drive GM vehicles sensor 1 is in front,2 is in back, but stiil in front of catalytic converter.
Car wont start or crank nothing works total silence
Check battery connections. or battery. Try jumping it with a booster box or jumper cables. If nothing. Check your main fuse, it should be located in the black box under your hood. It is the huge fuse, (also could locate in the owner manual)
How to change airfilter in
Loosen the 2 air cleaner intake duct clamps from the Mas Airflow sensor and the throttle body. Disconect Intake Air Temperature sensor connector.
Disconnect the vent tube from the air cleaner intake duct. Disconnect Mas Airflow Sensor electrical connector. Unlatch the air cleaner cover clips and remove the air cleaner intake duct and air cleaner cover.
Change the filter and reinstall.
Over heathing
It could be anything from thermosta to intake leaking to cooling fan not working properly
My 2000 olds silhouette will start and run, as
First eliminate all vacuum or air leaks in the system. You may have a bad IAC ( idle air control) but try cleaning the throttle body first. Remove the intake snorkel, have someone hold the throttle wide open for you and scrub the back side of the throttle plate and surrounding bore with an old tooth brush and some carb cleaner. Be sure to spray some into the small holes next to the throttle plate. That should help stabilize the idle. If it still has a problem, replace the IAC.
Where is the traction system sensor
what type of vehicle are you talking about, normally the traction systems use the vehicle abs/ speed sensors to monitor traction of the vehicle
Not finding what you are looking for?