Top 20 2006 Chevrolet Express - Page 4 Questions & Answers

Dose it make a normal sound when you start the engine, then more then likely fly wheel ok, anf it's going to be the transmission, if not normal it's the fly wheel.

If you look at the gap between the fender and the grill on the outside edge of the grill at the level of the turn signal, you will see a grey tab, if you push on this tab while pulling out on the lamp assembly. The whole assembly should swing out and allow access to the bulbs.

Hope this is of some assistance.
Ed

Be sure that the parking brake lever is fully released. If the cable is broken it may not have the tension to return up by itself. Pull the parking brake release while with your other hand pulling up on the parking brake pedal completely.

first check your fluid level if it's low then check for leak. if every thing ok then you may try a filter change, it may help.

2006?? dealer only encrypted software

Just twist them before pulling. If you break any wires, replace the whole set, when putting on wires, put some silicone grease in the boots.

open rear door and will see access screws that hold tail light housing remove screws and tilt out housing

The leak can be coming from anywhere there is coolant in the system. the most common place for a leak on those engines is the water pump, Fallowed by the heater by pass hose. Sometimes the hose falls out of its holder and the fan rubs a hole in it.
You will need to find the leak and report back so we can try and assist you on the repair.

The cigarette lighter fuse also powers the scanner OBD2 plug.

if you turn the fan speed to high and you can hear a difference but nothing changes then you have a bad blend door

The codes for the radio are in the back of the owners manual.

There is a sensor in the front center of the van, that gets damaged by water. There is an error code to verify this issue, be sure to extract the code first.....

When replacing the sensor, also replace the final pig tail to the sensor, or have repeating issue much sooner than you would like.

WELL I WOULD TEST CAM SENSOR OR CRANK SENSOR THE CAM SENSOR CONTROLLS SPARK AND FUEL SIGNAL HOPE THIS LEADS YOU SOME WHERE

if its not working now your ground might not be making good contact look for a metal piece were it can be secured with a screw

try bulldog.com they have alot of wiring diagrams

Sounds like the blower motor resistor. Hope this helps! ~Derek~

hoorn take the wire off hook another horn up see if it is the horn itself if not it is the horn relay or the horn button

it should have two tabs one in the front and one in the back, my 96 express is like that, you depress the front one and lift up and it should come right off...very easy

any time towing you want to install a heavy duty cooler to save the life on the trans

THIS WILL HAVE TO BE PROGRAMMED with a tech 2 scanner. these radios vin lock and have to be cleared out has to be done by dealer