20 Most Recent 2000 GMC Yukon - Page 5 Questions & Answers

You need to replace cluster, 99-02 Silverado GMC all will work even if it has a trans temp truck is pre wired for it. I put a 02 Denali cluster in my 01 silverado no problems. GM can reprogram hours and odometer if you want.

most time on all these it is that the door lock mec wont release ...see if there is a plug in the cover from inside if not u will need to drill a hole in the panel and feel around in there till you get the release hatch then it will open then put a plug in the hole you made

In most cases a bad or broken ground at the sensor connection at the fuel tank.

under the dash on the drivers side. above the break pedal

This C code is what is designated as a Chassis code . The specifc code is a generic and means

C0281 - Brake Switch Circuit:

It indicates a problem with the brake lamp circuit. Inspect the switch and circuit.

Code C0281 is set if computer never sees the brake switch release after speeds above 15 mph during start-up.

Could be a sticky pedal or the calipers not releasing properly !

Hope that helps !

The abs unit may be bad, no its not simple or cheap.

yes very common issue with these truck. actully had one last week come in and one coming back in this coming week. what happens is the motor shorts to ground and will need to be replaced. you can unplug it for now so it does not kill your battery because it will. it is directly under drivers seat under vehicle.

let me know if you have any more question. there is no fix for it. it is an internal fault

new reostat unit

the lock ring will twist off the hooks and yes you need fuelline disconet tool sell them at auto zone pretty cheap

Just make sure that all your electrical components are turned off, such as your radio and lights. Some of the newer vehicles can be damaged if those items are left in the on position. It's a costly mistake. After that, same as older vehicles.

There is a resistor down below the blower fan on the inside firewall of the passenger side. Advance or Auto-zone carry them and they are not hard to replace or very expensive. You will have to have a small socket though. I am not sure it is a 6 or 8mm.

You will see a long plug about an inch and a half that goes into it. When they burn out you only get high as a default.

Hope this helps.

If it works ok with another door swich then the switch is bad on that door. If not then the door regulator moter will need to be replaced

pull the heater relay and have it checked the relay may be stuck or failed

Driver's side rear pinch rail

Your catylatic converter may be clogged if your loosing power or top speed is less than it was. You can check this when its running with a battery operated infared heat gauge. the temperature of the muffler should be around the same temp. as the catylatic converter.

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Pull back the weather seal and you'll be able to get to everything.

Have worked on quite a few of these and have never seen issue with calipers. I do know that you sometimes have to hunt parts for a Tahoe instead of a Yukon to get the correct ones.

It sounds like your fuel filter has got to the end of it's life and needs to be replaced. Once the fuel filter get's to dirty, the fuel pump can no longer keep the proper fuel pressure to the fuel injectors to have them work properly. The fuel filter should be replaced once a year or 30,000 miles to ensure that it's always clean. A dirty fuel filter will make the fuel pump work harder and shorten it's life time causing a costly fuel sending unit replacement. Good luck and be safe.

Depend cause you got a running light and another one thats a running like along with brake light.If its the one that has the brake light and the light comes on when you brake and not when you turn on the headlights then you have a bad bulb .Replace that bulb and your set.good luck