20 Most Recent 2000 GMC Yukon XL - Page 4 Questions & Answers

is the steering wheel locked

dump some coke on them it works.

have you checked to see if engine is firing? ignition module can go bad and you would loose fire and fuel at the same time. i replaced one on a chevy truck last week and it was located beside the ignition coil.

Go under the seat and take a look.

yes sorry to say with out hearing the sound my self it could be 6 one way half dozen the other but try a flush and see if that stops the buzz and over heating should be around 100 to flush or it also now could be low on atf try a top off first ( be sure not to over fill)

I guess we have to assume that this is an automatic transmission. There is nothing that would cause what I would consider to be a "knock" in an automatic transmission. If your front Universal joint is shot, I suppose that would sound like a knock when the spiders rattle around in the trunnions. Check the U-Joints.

Usually with headlights and brake lights you have to twist the bulb itself a 1/4 to 1/2 a turn to unlock it from the housing, then the bulb should just pull out.

The ABS module when active makes noise when it is trying to control the vehicle by applying "leave" and "press" mechanism. If the lights are coming on , it is possible that the ABS needs to be fixed. Take it to the authorized service centre to electornically diagnose and reset the codes.

THIS CODE IS 90% OF PEOPLES ISSUES TODAY. MAKE SURE GAS CAP IS NOT OLD AND ALWAYS TIGHT AFTER FILL UP. IF CODE RETURNS YOUR NEAREST MECHANIC THAT HAS A SMOKE MACHINE WORKS BEST

Either the dash light dimmer is turned off or the dimmer control is defective.

the left hand frame rail is the drivers side frame. good-day !

i have an 03 yukon and i just replaced the fuel pump and it ran for 2 hours then it just died on the highway. it turns over but will not start. whats wrong with it???

2000 GMC Yukon XL 1500 4WD:
Available engines: 8 Cylinders T 5.3L SFI

2000 GMC Yukon XL 2500 4WD:
Available engines: 8 Cylinders U 6.0L SFI

Hope this help (remember comment and rated this).

I've heard it can be done with some difficulty. It may help to unbolt the passenger seat and move it as far over as possible to get to door panel screws and fasteners. Take all the screws out and pop the bottom retainers out. Good luck. Let us know if it was possible.