Welcome to FIxYa.com
REMOVAL PROCEDURE The power window motor cannot be serviced. Replace the power
window motor as a unit with the regulator. 1. Raise and support the window glass. 2. Remove the trim panel. 3. Remove the water deflector. 4. Disconnect the harness from the electric window motor
assembly. 5. Remove the 2 bolts holding the glass to the regulator. 6. Remove the bolts from the window regulator. 7. Remove the window regulator assembly from the door
folding both sides together. INSTALLATION PROCEDURE 1. Install the regulator to the door. NOTE: Refer to Fastener Notice in Service Precautions. 2. Install the bolts to the window regulator. Tighten Tighten the bolts to 9 N.m (80 lb in). 3. Align the window glass to the regulator and install the
bolts holding the glass to the regulator. Tighten Tighten the bolts to 9 N.m (80 lb in). 4. Connect the harness to the electric window motor
assembly. 5. Install the water deflector. 6. Install the trim panel 7. Lower the window. Inspect the operation
Thank you for using FixYa.com
Regards, Lee Davidian
295 questions posted
Usually answered in minutes!
721 Questions
500 Questions
426 Questions
128 Questions
17 Questions