20 Most Recent
1998 Oldsmobile Aurora - Page 9 Questions & Answers
How to change water pump housing 1998 aurora
When removing the pump unit with special tool (some auto-parts stores rent them), TURN CLOCKWISE TO LOOSEN the pump-unit, counter-clockwise to tighten. The Torq Specs for the pump-unit is: 73 Foot Pounds. There are stop tabs on the pump-unit that mate with the tab stoppers on the main water pump housing unit.The Torq Specs for the front cover (5 bolts) and water neck cover (2 bolts) is: 89 Inch Pounds. Those small bolts tighten normal, clockwise.---------The guide to replace water pump is as follows:--- Click the link below:---
http://technoanswers.blogspot.com/2011/04/how-to-change-water-pump-housing-1998.html
---------------
This will help.Thanks.helpmech.
Does the 1998 oldsmobile aurora
4.0 'shortstars' do not have a bleeder screw, they are filled at the surge tank which is higher than the coolant anywhere in the engine compartment-fill it to the full level when COLD, and check for pressure in the system when the engine is hot (squeeze the top hose, it should be solid, not easy to callopse). Your surge tank also holds pressure so your cap has to seal tightly with no leak through the overflow tube.
My 1998 aurora surges all
Need to replace your throttle control sencor, This controls the fuel flow to your engine, Best of luck to you.
My aurora ran out of
Antifreeze leaking into ur oil is not good,this will mess ur eng. up very bad it sounds like u have a busted head gasket,u need to have this checked
Speed odometer stops cruise doesnt
The most likely cause,besides the speedometer being bad is the vehicle speed sensor in the transmission.It is mounted on the outside of the transmission and is fairly easy to replace.
With car off & key
This is a problem with the multi-function lever [the one with the turn signal and headlamp controls]. It needs to be replaced. Unfortunately, this is a somewhat expensive repair.
Where is the fuse box
The main fuse panels [actually they are small black boxes] are located under the rear seat on the driver's side of the car. There is an auxiliary fuse panel on the extreme left side if the dash which you can see when the driver's side door is opened.
My heater blower goes off
There's a blower control module on the passenger side of the car near the glove box which has failed.
Speed ometer ,heater controlls andcar computer
There's a fuse under the rear seat labeled Inst #1 or Inst #2 which may be blown. Try that first and hopefully that will fix the problem. If the fuse keeps blowing, then you've got a real problem because that circuit runs all over the car [at least a dozen different locations] any one of which may be in trouble. Good luck!!
Why do I smell Antifreeze
Head gaskets are quite common to fail on Auroras. If it leaks internally, coolant burns and causes a smell to exit through the exhaust.
I am looking at a
To be honest, when the electrical wires and parts get wet, there can be all kinds of problems. The best advice I can give you is have it professionally scoped.
On a 1998 Oldsmobile Aurora,
IF YOU DONT SEE STARTER UNDERNEATH CAR NEAR FLY WHEEL AND YOU HAVE THE 4.0L ENGINE STARTER LOCATED UNDER THE INTAKE MANIFOLD JUST LIKE THE 4.6L ENGINES IN CADILLACS.YOU HAVE TO REMOVE INTAKE TO REPLACE STARTER.
How do I fix rear struts?
you don't fix them - they are not serviceable except for replacing. if they're bad they need to be replaced.
Waterpump leak
Hello bladresha: My name is Roger and I will help you. The
water pump on the 4.0 engine is located at the rear of the motor inside of the water cross over tube. It does require special tools in order to remove and install. This pump does not bolt in or on to the motor. This is a twist and lock in pump. Just like the Cadillac
Northstar motor. You will need to remove the upper hose housing from the crossover tube. Look inside of the housing and you will see the water pump. You will need to use the special tool
in order to unlock the water pump. Pay close attention to the water pump when removed. There will be a notch in one of the ears. This is a location notch. The new pump must go in the same notch. I have attached a picture that shows the water pump location. Should you need further help please just ask. Please rate the answer. Thank You for using Fix Ya. Roger
Not finding what you are looking for?