Top 20
2000 Mercedes-Benz CL-Class Questions & Answers
Heat blows cold when idling
Most cars today use vacuum to operate the blend doors in the heater box. It is possible that there is a leak or crack in the vacuum lines leading to your heater control and when at idle, the vacuum level is not enough to keep the door engaged. They are spring-loaded and will change to a default position when there is no vacuum present.
2/29/2016 1:48:49 AM •
2000...
•
170 views • 0 helpful votes
My car completely died while driving and now no
run fault codes to find failed sensor /servo.. Have the battery load tested as it may have a broken bridge between plates or a dead cell. Check fusible links near the battery are complete and not blown
10/26/2013 8:50:10 PM •
2000...
•
45 views • 0 helpful votes
Driver door doesnt work
could be that switch in door has loose connection or maybe bad. If it was a fuse none of the doors would work... hope this helps and if so please rate my post and good luck.
8/15/2012 6:06:09 AM •
2000...
•
41 views • 0 helpful votes
Need fuse diagram for 2000 cl55
W215: The second generation of the CL is the
W215 - chassis coup? of 2000-2006.
W215 01 - Fuse Box & Relays layout04 - Fuse & Relays Trunk05 - Fuse CockpitFor additional details about
Mercedes-Benz Class CL55 AMG, CL500 and CL600, or if you don't have this document visit our Owners Manual link to check and download this file in PDF format.
I hope this helps, and just keep in mind that your feedback is important
and I'll appreciate your time and consideration if you leave some
testimonial comment.
Have a nice day and thanks for using FixYa.
Jose.
10/18/2011 1:54:53 PM •
2000...
•
2,726 views • 0 helpful votes
Looking for good car with bad engine
why you want bad engine good car.bad engine going cost money to fix if you got good engine for car you are good to go.
11/19/2011 3:03:21 AM •
2000...
•
63 views • 0 helpful votes
When i turn the steering wheel to the right get
There are bearings on top of the strut. this is probably your noise. It's not hard to remove the strut, three nuts on top and two bolts on bottom, but you will need a coil spring depressor to remove the bearing plate at the top of the strut.
2/6/2011 12:26:23 PM •
2000...
•
301 views • 1 helpful votes
I have a pleasure of owning MB CL 600 from year
Hi! Adjustment of the mirror on the driver's side when on reverse is definitely unusual. You will have to have the wirings checked for the reverse is triggering the side mirror. Regarding the block heater, yes it is possible to put one but be sure that an expert will do this for this is a sensitive matter. Hope this helps and thank you for using FixYa!
9/2/2010 8:02:38 AM •
2000...
•
86 views • 1 helpful votes
I have a Mercedes Benz C250 Turbo Diesel that is overheating.
Try running the engine with the water filler cap off and see if the water level goes up and down at the same time as you rev the engine. If it does then you have blown headgasket and your water will be being pumed out through the exhaust.
Rob
9/25/2009 1:24:59 PM •
2000...
•
666 views • 2 helpful votes
My problem with the navigator system because my
you will have to go to mercedes for this program it will be expensive. if you know the brand gps you may have the company itself send it to you but this too will probably be very expensive. i know the updates for the navz are starting at $300 and it goes up from there.
11/1/2009 8:36:07 PM •
2000...
•
187 views • 1 helpful votes
My stereo says 'muted' and does not work except when in reverse
They have a speed dependent volume so it does have wheel speed sensor input which could cause the wierd reverse only operation. It sounds like a software problem-I would try version coding the head unit(which will have to be done if you have a c.d. player or telephone in the car. Try to unmute it from the steering wheel buttons it may think there is a phone in the car and is muting the radio for phone operation. Your best bet is to pull codes and version code with a s.d.s. machine or at least a hand held tester but the majority of after market scan tools will not communicate with the d2b system which is your radio or sound system. good luck I hope I have been helpful
9/16/2009 4:27:04 AM •
2000...
•
454 views • 1 helpful votes
Whistling noise when i rev my mercedes c 220 cdi 2004 plat
If the engine is a diesel that is equipped with a turbocharger, I would look for a pressured air leak at any and all hose connections. Especially when the engine is running at accelerated speeds which cause the turbo to operate as a charger. Check any and all belts for slipping, Alternator, P/S,etc.,
Smog code P0015
it is a cam shaft timing code this can be triggered by late oil changes try and change the oil and reset the light
How do you reset the
I will need to know the year make and model of this car, as far as the brake light if the sensors are new then close all doors and trun the key on without starting the car and wait about 15 seconds and the brake pad warning light will go out, send me the info of the car and i will tell you how to reset the service light as the method changes for year to year and model to model and also depends on what type of cluster it has. good day.
A Bumag compactor with a
you have to remove the fuel rack timeing bolt and insert a pin to keep the fuel rack fully to the rear
and then insert the fuel pumps carefully as not to bend the fus
el rack
Not finding what you are looking for?