20 Most Recent 1995 Mitsubishi Mirage Questions & Answers

0helpful
1answer

My mitsubishi mirage is 1.5L. The engine revs

Could be multiple. I would look for bad Motor Mounts or Worn Shifter Linkage Components, to address the Transmission Issues. The Idle Issue could be an Idle Air Control Valve. 1995 is before OBD2. So, Check Engine Lights are useful, but not as much as they are 1996 and up.You didn't mention a Light on. Get a Repair Manual. You are going to need it.
1/3/2018 5:09:29 AM • 1995 Mitsubishi... • Answered on Jan 03, 2018
0helpful
1answer

Repair shop say I need Automatic Compressor

everything but get help from an ac specialist shop you did not use a vacuum pump to get the air out of the system , That is one fault the compressor will start to pump once the freon pressure reaches high enough to activate the low pressure switch freon is put in using pressure gauges the part mentioned may be the climate control module as it controls the ac compressor along with the heater to control cabin temp
12/13/2017 1:12:04 AM • 1995 Mitsubishi... • Answered on Dec 13, 2017
0helpful
1answer

My 1995 Mitsubishi Mirage 1.5L

before you go any further pull the oil filler cap from the rocker cover and see if the cam shaft and rockers are moving when you are cranking it over suspect a broken timing belt as that will not allow any spark
6/23/2017 3:23:52 AM • 1995 Mitsubishi... • Answered on Jun 23, 2017
0helpful
2answers

Why aren't my break/tail lights working on my 1995 Mitsubishi mirage? No fuses or bulbs are blown.

Well the brake-turn signal and tail lights are on two different circuits, but share a common ground. If the ground is good, and the parking and turn signals work in the front, it could be a wiring problem.
6/26/2016 1:52:23 AM • 1995 Mitsubishi... • Answered on Jun 26, 2016
0helpful
1answer

Mitsubishi 4G91 timing diagram

26220017-gixnvmegknfegt3ailar3alb-2-0.jpg
6/17/2016 4:08:35 AM • 1995 Mitsubishi... • Answered on Jun 17, 2016
0helpful
2answers

M a p mirage95

Anytime you replace a sensor or ignition parts on a Mitsubishi, (also have a 95 Mirage) the whole **** thing goes out of whack and won't start. Have to reset the ECC (ECM) supposedly by allowing it to drain of juice (disconnect both battery cables for about a day) See if this works for you
2/25/2016 3:50:02 AM • 1995 Mitsubishi... • Answered on Feb 25, 2016
0helpful
2answers

SRS light stays on. Where is the fuse that will deactivate?

hi mate, i suggest this should be done by dealership, it's a little dangerous for you to do it yourself.SRS system is a very very important secure system of your car, so should be very carefulgreetings
12/6/2015 12:32:36 PM • 1995 Mitsubishi... • Answered on Dec 06, 2015
0helpful
2answers

TENGO UN MITSUBISHI DE 95 , LA TRANSMISION 1.8

quizas necesita revisar sensores de transmision,tambien el nivel de aceite,ya por ultimo quizas sea que ya empezo a resbalarse y va a necesitar una transmision nueva o usada.
4/9/2015 3:46:12 PM • 1995 Mitsubishi... • Answered on Apr 09, 2015
0helpful
1answer

Which mark is the five degree mark for the ignition timing

. I was reading on the net( stop-the-star- program.3084.x6.nabble.com that the initial program is for 5 degrees advanced but all shops state that the reading from the plug lead is 10 degrees -even new vehilces and it is set by the ECM program this site is a forum for this discussion
12/27/2014 6:11:33 AM • 1995 Mitsubishi... • Answered on Dec 27, 2014
0helpful
1answer

Have no heat just blows cold if you drive the car for 30 minutes or so it will get luke warm but its still cold any help?

Is your engine temperature gauge reading normal? If not it could be a Possible head gasket. If it reads normal then could be a clogged heater core. Best to have system flushed out.
11/17/2014 4:08:34 PM • 1995 Mitsubishi... • Answered on Nov 17, 2014
0helpful
1answer

How do I check to see if the timing has jumped, or the belt has broke?

check to see if the cam shaft is turning ( broken belt)
11/4/2014 12:50:52 AM • 1995 Mitsubishi... • Answered on Nov 04, 2014
0helpful
3answers

How to change out flasher fuse

Here ya go...please don't forget to rate!

1997–00 Mirage engine compartment fuse location chart

f452915.gif
The turn signal and hazard flasher unit is located in the interior fuse panel located under the driver's left side knee protector. They are replaced by simply pulling them straight out. Note that the prongs are arranged in such a way that the flasher must be properly oriented before attempting to install it. Turn the flasher until the orientation of the prongs is correct and simply push it firmly in until the prongs are fully engaged
10/17/2014 4:41:14 PM • 1995 Mitsubishi... • Answered on Oct 17, 2014
0helpful
1answer

Location of the diagnostic connector

Front seating area, driver side, driver side of steering column, mounted behind upper dash panel that's it
10/14/2014 7:59:11 PM • 1995 Mitsubishi... • Answered on Oct 14, 2014
Not finding what you are looking for?
1995 Mitsubishi Mirage Logo

239 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Mitsubishi Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Mirage Mitsubishi

  • Mirage Mitsubishi

Most Popular Question

no heat just blows cold drive car 30

  • Cars & Trucks
Loading...