20 Most Recent 2000 Dodge Neon Questions & Answers


The service and repair manual with diagram provide you step by step help to locate and fix the problem easily and you will get the manual from the given link https://toolsnyou.com

2000 Dodge Neon | Answered on Aug 31, 2019


was replacement running before being placed--is it the same so computers didnt need to be flashed --are all sensors installed and hooked up correctly

2000 Dodge Neon | Answered on Jul 09, 2019


Check your volts of the battery. Should read around 12.8 or higher. While running it should read about 14.5 Sound like you have something in the fuse panel draining the battery. Your best bet is watching YouTube to properly check the battery and all the fuses with a multimeter.
Hope this helps

2000 Dodge Neon | Answered on Apr 23, 2019


sounds like you broke the bladder in the brake booster

2000 Dodge Neon | Answered on Feb 21, 2018


P1193 is an intake air temp code, there is a sensor somewhere within the filter box or the intake tube (large rubber tube running to the intake) with a plug that normally has two wires. You can remove the sensor and clean it (this will sometimes fix the problem) or replace it. You should reset the codes to verify the fix.

2000 Dodge Neon | Answered on Oct 31, 2017


CODE PO202 FUEL INJECTOR 2 CONTROL CIRCUIT MALFUNCTION CONDITIONS.POSSIBLE CAUSES INJECTOR 2 CONTROL CIRCUIT IS OPEN OR GROUNDED BETWEEN THE INJECTOR AND THE PCM.OR INJECTOR 2 HAS FAILED ALSO PCM HAVE FAILED.ONLY WAY TO TELL IF PCM FIRING INJECTOR 2 IS DISCONNECT 2 INJECTOR ELECTRICAL CONNECTOR HOOK NOID LIGHT TO INJECTOR 2 CONNECTOR CRANK ENGINE.THE NOID LIGHT SHOULD BE BLINKING.IF NOID LIGHT STEADY YOU HAVE FAULTY PCM.IF NOID LIGHT NOT WORKING YOU HAVE BAD GROUND OR OPEN WIRE ON INJECTOR 2 ELECTRICAL CONNECTOR.

2000 Dodge Neon | Answered on Sep 11, 2017


seems like a considerable effort when the wreckers/junk yards are full of good units
may be the bolts are part of the rubber mouldings
have you tried a hydraulic press to push them out

2000 Dodge Neon | Answered on Jul 15, 2017


you need the compressor running to get freon into the system
using gauges on a manifold you allow the compressor to suck the gas in to the system until you get a pressure reading at the high side gauge
That is the correct amount of gas for the system
take it to an accredited ac specialist shop to have the job done properly

2000 Dodge Neon | Answered on May 20, 2017


why not get an alternator for a neon instead of caravan

2000 Dodge Neon | Answered on Dec 01, 2016


Vacuum Leak Present IAC Fully Seated

http://www.autocodes.com/p1299_dodge.html

2000 Dodge Neon | Answered on Oct 23, 2016


You have to replace the whole mount. They aren't that expensive. I suppose you could replace just the rubber, but they don't sell them that way.

2000 Dodge Neon | Answered on Feb 28, 2016

Not finding what you are looking for?
2000 Dodge Neon Logo

940 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2002 Dodge Neon
2002 Dodge Neon

839 Questions

2004 Dodge Neon
2004 Dodge Neon

733 Questions

2003 Dodge Neon
2003 Dodge Neon

727 Questions

2005 Dodge Neon
2005 Dodge Neon

688 Questions

2001 Dodge Neon
2001 Dodge Neon

534 Questions

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Neon Dodge

  • Neon Dodge

Most Popular Question

2000 doge neon batry changed now trun

  • Cars & Trucks
Loading...