20 Most Recent 1992 Buick Century Questions & Answers

it's connected to throttle body you have to remove it to change thermostat V6 3.3

10w30

Transaxle?Really need a lift to do it safely& no --you never install a salvageyard unit,pure junk,always rebuild yoursNot a driveway job,you could get hurt

On this website you find fuse box diagram and description for Buick Century (1992) http://www.carknowledge.info/buick-century-1993-fuse-box-diagram

Under the hood on the the fire wall

Normally you would use a scanner - you might be able to use a meter to measure the resistance in the sensor, I think it should be near zero when the throttle plate is closed.

Check this website Buick Century 1993 fuse box diagram CARKNOWLEDGE

I cant find my fuel pump fuse? on a 1992 Buick Century

White smoke is usually steam, you either have a bad radiator cap or a hose with a hole in it.

Found this info. I don't know liter size of engine? For the 2.2L rotate the engine forward slightly. Some, I have removed the squirrel cage from the blower, then removed. I don't know if that would be applicable on your vehicle? As far as the power steering pump, I'd have to look at mounting bracket. All I can do is throw out ideas, I can't see anything from here.

Ohms should read 11 to 15 at the injector pins. Power at the plug should be battery voltage. 12.5 with key on. Use a noid light to see if the injector wires/PCM is firing the injectors. the light should flash when cranking the engine over.

I do not have a diagram for you but you can get that from a parts store. If you follow the top hose back to the engine you will find your thermostat. You will probably have to take a couple of other things off to get to it like you air intake. Once you get to it this is a very easy fix. It is located in the fixture under that hose you tracked back.

To set the clock, check this procedure:
1. With the radio ON or OFF, press SET. The SET indicatore will appear on the digitas display for five seconds.
2. You must begin to set the clock to the correct hour and minute during those five seconds. Press and hold SCAN until the correct hour appears on the display.
3. Press and hold SEEK until the correct minute appears on the display.

Hope help with this, remember rated this post, and TY for using Fixya.

take the bolt out of the motor mount and jack the engine up a little you can just remove the long bolt on the bottom of the mount you do not need to remove the mounting bolts to the engine.