20 Most Recent 2005 Chevrolet Express Questions & Answers


Try resetting the computer. Take negative battery cable off for a few minutes then replace it. Hope that fixes your problem.

2005 Chevrolet... | Answered on Sep 22, 2017


I think the socket for the light that is not flashing is slightly melted. the contacts are probably not touching the light bulb properly. you might be able to tug on the contacts to make better connect with the bulb

2005 Chevrolet... | Answered on Jul 21, 2017


get a good fuel addative to clean the fuel system , sensors etc as could just be a built up of carbon,varnish etc , take for a good long drive and get engine very hot for a good 30 minutes

2005 Chevrolet... | Answered on Jun 11, 2017


check transmission fluid level also look and smell fluid if smell burnt and or color is brownish {color is a red } than change fluid and filter it may help but if metal present or heavy filings on pan magnet [and the problem persists } you have a problem that may need a shop to repair or replacement unit

2005 Chevrolet... | Answered on Jul 10, 2016


Two different types of clamps are used on GM radiator hoses.

Spring Tension Type
Screw Type

You may have to access the lower rad hose from underneath the vehicle if you cannot reach the lower hose from the engine compartment.

2005 Chevrolet... | Answered on May 15, 2016


DTC P0753 1-2 Shift Solenoid Control Circuit - this code does not mean the shift solenoid is bad . It states control circuit , wiring , the driver inside the PCM , power to the circuit .
Install a scan tool.
Turn ON the ignition, with the engine OFF.
Important: Before clearing the DTC, use the scan tool in order to record the Freeze Frame and Failure Records. Using the Clear Info function erases the Freeze Frame and Failure Records from the PCM.
Record the DTC Freeze Frame and Failure Records.
Clear the DTC.
Is DTC P0758 or P2761 also set?
YES - Go to Step 3
NO - Go to Step 4
Inspect the IGN 0 fuse for an open. Refer to Circuit Protection - Fuses in Wiring Systems.
Is the fuse open?
--
YES - Go to Step 12
NO - Go to Step 5
4
Use the scan tool in order to command the 1-2 SS valve ON and OFF three times while listening to the bottom of the transmission pan, a stethoscope may be necessary.
Does the solenoid click when commanded?
--
Go to Intermittent Conditions in Engine Controls - 4.8L, 5.3L, and 6.0L
Go to Step 5
5
Turn OFF the ignition.
Disconnect the AT inline 20-way connector. Additional DTCs may set.
Install the J 44152 jumper harness (20 pins) on the engine side of the AT inline 20-way connector.
Turn ON the ignition, with the engine OFF.
Using the J 35616 GM terminal test kit, connect a test lamp from terminal E of the J 44152 to ground. Refer to Automatic Transmission Inline 20-Way Connector End View .
Does the test lamp illuminate?
--
YES - Go to Step 6
NO - Go to Step 15

This is a long diagnostic flow chart an I would think you do not have a scan tool . Your best bet is to take to a transmission shop .

2005 Chevrolet... | Answered on Mar 19, 2016


it means that there is a problem concerning the engine or transmission and the ECM has placed the system in limp mode which is designed to allow you to get the vehicle out of harms way only
check water in the radiator, check for overheating, sump and transmission oil levels, drive belts, abs and tract control system
have the fault codes read to determine what cause the limp mode setting.

2005 Chevrolet... | Answered on Jun 13, 2015


bad relay on rear by the motor

2005 Chevrolet... | Answered on Apr 23, 2015


$50 at Crutchfield if your van doesn't have OnStar - probably more if you do:

Crutchfield

You can look thru Metra's site:

Metra Electronics Car Audio

2005 Chevrolet... | Answered on Apr 01, 2015


could possibly head gasket . check for air bubbles in radiater

2005 Chevrolet... | Answered on Feb 03, 2015


There is a spring loaded tension pully that needs to be depressed. I believe is has a 1/2 inch square socket female end on the front of tension pully that you can use a 18" or 20" breaker-bar to get leverage to reduce the tension. Reduce the tension remove belt and just reverse the process to install new belt.

2005 Chevrolet... | Answered on Jan 27, 2015


Check battery connections carefully. Check neutral safety switch if automatic trans.

2005 Chevrolet... | Answered on Dec 19, 2014

Not finding what you are looking for?
2005 Chevrolet Express Logo

205 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Express Chevrolet

  • Express Chevrolet

Most Popular Question

05 chevy express van need know harness

  • Cars & Trucks
Loading...