2005 Chevrolet Express - Page 4 - Answered Questions & Fixed issues

the fuel is located on the drivers side lower dash, look for the fuse mark cigarette, one can use a small pliers or the plastic fuse remover

change your head light switch.

The problem could be a problem with the wiring to the speakers or the speakers themselves could be blown. I had the same problem with my Camaro once. I would try to replace the speakers and see if that fixes the problem. If not then I would either rplace the wiring or take it in to have it done.

THERES A CONTROL MODULE FOR THE GAS GAGE COST ABOUT $200 I know my daughters chevrolet SUV DID SAME THING

you have to back track the wire from the sending unit to the guage. If there is no power when you put your volt meter to the wire and the body you should get movement. There could be a break in the wire, or it could be a bad guage or a sending unit. obviously the sending unit is the hardest to fix. So start with the wire, then the guage then the sending unit. If you do replace the sending unit. I personaly would replace the wire no matter what. One solid wire with a good heat and weather proof coating.

Yes there is and here is a link where you can get it and they have the step by step to install. 
Good luck and hope this helps: http://replacementradios.com/product_info.php?products_id=779

lOOK UNDER THE REAR OF THE VEHICLE ABOVE THE SPARE TIRE ON A CROSSMEMBER BETWEEN THE FRAME RAILS.

Easy, simply trace the bottom radiator hose (lower left of the radiator) from it's connection point on the radiator to it's connection point on the engine, that's where the thermostat is located.

it sounds like you could be right. all wiring looms are the same on each model of every car, as it saves money making specific ones for each car.

hope this helps.

yours is a common product with both chevy and gmc. it most cases it is not a real problem as far as operating the vehicle goes, but oh so annoying. I recommend that you drive it another hundred miles and take it to an autozone where they usually have a computer check for free.

here is a link to a repair guide for your vehice that will help you with the headlights along with any other thing you might need.
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152800b4a31

Ma wish to check starter it could be bad or have loose wires on it. There may be a starter relay in the fuse box under the hood it may also be bad.

Question edited for clarity. Chimes are normally activated from the Body Control Module from information given by a switch or sensor, so pulling a fuse is not an option. https://www.google.com/search?q=1982+CHEVY+EXPRESS+VAN.+Dinging+bell ..

Not told! However, this gives a clue right here on Fixya

SOLVED: Location of fuse box for license plate light on a - Fixya

https://www.fixya.com > Forum > Cars & Trucks Oct. 23, 2011 - location of fuse box for license plate light on a 1998 chevy cargo van - Cars & Trucks question. 1 answer · 3 votes: The license plate bulb is fed off the same fuse as the parking lights/tail lights.

Chevrolet Express (2003-2020) fuses and relays

https://fuse-box.info > chevrolet > chevrolet-express-20... Fuse box diagram (location and assignment of electrical fuses and relays) for Chevrolet (Chevy) Express (2003, 2003, 2005, 2006, 2007, 2008, 2009, 2010, ...

https://www.google.com/search?q=2017+Chevy+Express+2500.+I+need+the+backup+camera+wiring

The rear auxiliary heater and air conditioning control replacement procedure starts with removing the HVAC control assembly bezel (trim) from the headliner. Next, the headliner must be lowered in order to access the rear of the HVAC control assembly. This requires removal of the windshield garnish molding (A-pillar trim) and upper pillar garnish molding (B-pillar trim) at a minimum. You may be able to gain the necessary access by allowing the headliner to "hang" slightly rather than removing it entirely. After this is done, the electrical connectors can be disconnected and the HVAC control assembly can be removed from the headliner. You can read more here: https://www.yourmechanic.com/article/how-to-replace-an-ac-control-module-by-spencer-clayton

https://www.modifiedlife.com/2019-chevrolet-express-radio-wiring-diagram/

Overheating fuel pump or ignition module?

2004 Chevrolet express 3500 does not have A filter for the cab or a filter on the incoming air that comes in through the area behind the hood in the center of the van. You can see the vent intake or vacuum operated blending door if you look through the plastic screen part of this trim piece with a flashlight it is down and to the left. My Xpress 3500 Cutaway has a trail light motorhome attached I'm assuming that this is also true for the 2500 van. I found this out the hard way this area got filled up with sand and leaves there's a drain at the bottom and it was clogged the blending door or vent door allowed the sand leaves to go directly into the blower motor and then next the heater core this all had to be washed out and the heater core sucked clean with a vacuum since it is nearly impossible to access it through the passenger side of the cab I removed the blower motor, cleaned that and then used a vacuum with an attached piece of PVC pipe three-quarter inch and a 90 on the end and carefully put it through the box where the blower was and into the side where you can see the heater core itself.. the only thing I was able to do from the passenger side was pull the cover down and out exposing the ac coil enough to blow compressed air through it back towards the heater core . If I'm not mistaken after you remove the screws holding this pice on the passenger side below the dashboard , where a glove box would of been there are screws that are not accessible you are directed to cut the top side seam to remove it . This I found from reading the instructions for replacing the heater core ,I'm hoping to find some sort of filter offered to fix the intake, if not I think a piece of washable filter material cut accordingly and placed in front of the vaccume actuated blending /vent door , the 1" thick green or blue hvac washable material is what I am referring to . You would need to take the windshield wipers off and the plastic piece below that spans most of the area between the back of the hood and the bottom of the windshield you could put a pice ofthe washable filter material here in front of the vent door . As for the interior cabin filter I'm hoping some one makes in

fix the leak is normally the easy way