1995 Mercedes-Benz E-Class - Answered Questions & Fixed issues
Driver's door unable to lock unlock
First, you really don't give us enough info to help you. What kind of a car? Power door locks? Do you mean the key won't turn in the lock? Is the lock frozen? What country are you in? In the USA, just call a locksmith and they can come out slip a special tool down the window to open it up.
1/9/2018 6:25:26 AM •
1995...
•
Answered
on Jan 09, 2018
•
80 views
I have a 1995 E220 auto saloon (petrol) the car
Apart from plugging the car into a diagnostic no its probably cheaper to change the part it could also be a faulty coil pack but if its like my m reg c class there is 1 per cylinder would start but run rubbish if the parts buttons just replace it then you kniw if its that or not
12/2/2017 7:24:23 PM •
1995...
•
Answered
on Dec 02, 2017
•
75 views
Hi we are replacing our water pump on our merc
I would remove all the belts as they will get in the way draw a diagram to show how the belts go on just remove the bolts that look like there conected to the water pump dont worry about removing the wrong ones as the rest are just for thev timeing belt cover and wont make any difference as long as they go back in hope this helps ivan
11/7/2017 7:24:58 PM •
1995...
•
Answered
on Nov 07, 2017
•
69 views
E220
If it has a free wheeling clutch fan it spins faster as the engine heats up.
12/6/2014 8:25:07 AM •
1995...
•
Answered
on Dec 06, 2014
•
56 views
ABS LIGHT STUCK ON NOW ALSO OIL LIGHT
With out having the car its a bit hard. when the abs light comes on it means a fault of some kind, low brake fluid , faulty censer at the front wheels, a lump of mud can cause them to give a fault report. The engine oil pressure switch may be at fault . Before it is driven again remove the switch and fit a oil pressure gauge start and read the pressure. if OK fit a new switch, if not don't drive the oil pump bypass valve may have stuck open or have a broken spring.
12/6/2014 8:10:04 AM •
1995...
•
Answered
on Dec 06, 2014
•
71 views
I have replaced the brake switch in my 95 Mercedes
With the ignition on check there is Voltage on one side of the brake light switch with the brake pedal at rest , depress the pedal and there should be voltage at the other terminal . if not bad switch, if ok blown bulbs or bad connection.
12/6/2014 7:08:07 AM •
1995...
•
Answered
on Dec 06, 2014
•
120 views
Burning smell
sound like you have had a circuit over load from a short and now there will be burnt wires under the dash . Check for what wires have burnt and then check the fuse size for that circuit as it should have burnt out before the wires did.
3/8/2014 10:04:32 AM •
1995...
•
Answered
on Mar 08, 2014
•
291 views
1992 Mercedes Failed Air Care causes
Have the fault codes read. Replace faulty items. Use only genuine items as replacement as non-genuine are not always compatible with the OEM fitted CPU units. This results in the fault codes not cancelling out
5/18/2013 6:58:38 AM •
1995...
•
Answered
on May 18, 2013
•
96 views
Battery went dead had to jump start, now cd player wont work on 2006 mercedes
It should be in the manual supplied with the car. If not call mercedes and give them your vin, reg private detail etc and if you get a nice person,problem will be solved. It happen to me, but not a merc that you gladly own. I'm n battery not sure about this advice but a merc uses a high voltage and you may need a new battery.
12/20/2012 11:19:34 AM •
1995...
•
Answered
on Dec 20, 2012
•
188 views
Whee is engine computer ecm locate on benz 1995 e420
RUN THE scanner and computer do not waste the time and your money. The EMC OR BCM is faulty or speed sensor faulty with the scanner determine which is faulty.God bless you
10/4/2012 12:48:57 PM •
1995...
•
Answered
on Oct 04, 2012
•
183 views
E320 starts but will eventually stall and wont turn on until 30 minutes to 1hour. put a fuel pressure gauge and when vehicle works goes up to 50 but when it doesnt turn on it wont show anything. told
Hello
The
Engine and Automatic Transmission (not applicable to manual
transmissions) in this vehicles drive train are fully electronically
controlled by a computer called the PCM and TCM (Power Train Control
Module, Transmission Control Module). When a problem like this or
other drive-ability related problems occurs the computer stores a
record of the problem (there are of course some exceptions to this,
like the fuel pump, engine coolant temperature sensor and MAF sensor
for instance) in the form of a fault code in its memory, to read
these fault codes you must have the systems memory scanned with a
special tool. Once the fault code(s) are read you then must perform
the appropriate diagnostic testing to find and resolve the problem(s)
DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN HAS DIAGNOSED
THE PROBLEM TO AVOID SPENDING YOUR HARD EARNED MONEY ON PARTS THAT
MAY NOT CORRECT THE PROBLEM. Also always check fuel pressure for
correct spec for your make and engine type.
9/19/2012 7:35:34 PM •
1995...
•
Answered
on Sep 19, 2012
•
640 views
I'M LOOKING FOR A LOWER WIRING HARNESS FOR A 1995 S500 MERCEDES BENZ
You may be stuck with a dealer sorry that would be stealer or a salvage harness. There are quite a few places to get much better prices on parts such as autopartshausaz but I don't believe I have seen a harness listed. i would try parts finder.com and I'd hit a few of the forums. The guys there are pretty helpful and someone might be parting out the car etc.
8/17/2012 3:51:59 AM •
1995...
•
Answered
on Aug 17, 2012
•
193 views
Not finding what you are looking for?