20 Most Recent
1992 Chevrolet Corvette - Page 6 Questions & Answers
1992 corvette no comunication between modules
I had a similar problem on my 92 LT1 and it turned out to be the opti-spark was bad not signaling the injectors to pulse, if your bypassing the VAT to turn it over then the injectors should fire as well, on the 92 the crank sensor is built into the opti-spark distributor as well, if it turns out to be the opti-spark spring for the MSD sealed and vacuum vented cap or you'll just be replacing the thing every six months, you can test the opti up were it runs into the coil, I dont remeber the exact proceedor but it is on line,
Ok so altinator whent out
They are located at the battery terminal of the starter solenoid. There is a fusible link in the charging system, you need to check at the back of the alternator at the large black wire to see if you have 12 volts. If you do not have 12 volts, then the fuseible link is bad.
-------------
And for fusible link .This cable comes from the starter then to the battery. Its(the fusible link)located inline with this cable, the cable must be replaced to repair this. You can check it with the car on or off.---------------
For more details:------------
Follow the wire harness to the starter it looks like both the red and the red/black or red wires go through a fuseable link directly to the starter selenod directly back to the battery. You may actually have a series of three.
You can check to see if you have power at the starter with a meter - ground one pin and check to see if you get 12 V when the key is turned ( do not turn over engine) .
Check the fuseable links with a meter for continuity. They may look good but may be bad.
Thanks. Keep updated for any more query. You can rate this
solution and show your appreciation.
1992 corvette my gas gauge stays on full
remove the fuel lid( 4 screws) than remove the fuel pump. there you will find the sending unit. there will be a float. check this. some times it will get hungup on some wires.
1992 Corvette headlight repair/ replacement Light
Do you hear a clicking noise as if it is trying to close? If so, it may be the gear located in the h/light motor housing that needs replacing. You can purchase these for anywhere from 24.99 - 65.00 each, online. Hope this helped.
Where is the courtesy light delay switch located
The courtesy lights as well as the map lights (located on the bottom side of the rearview mirror) will come on when you open a door (unless it's bright outside) and will remain lit for approx 30 seconds and then will turn off. This is verbatim from my '92 Corvette owners manual - The map lights can be turned on and off, but there isn't a delay switch, persay. Hope this helped.
Not finding what you are looking for?