20 Most Recent 2000 Chevrolet Tracker - Page 6 Questions & Answers

you need to get air out of your hidraulic system, if you dont know to do it, go to the garge.

if you have not changed the camshaft position sensor you need to do that sounds exactly like my problem got the new fuel pump and filter in there and it was fine for a month then same thing started happening again, been fine for 7 months since I changed my camshaft position sensor

What kind of a noise is it? Is it a squeal or or a metal on metal sound? Does it have A/C?

Unfortunately there is no solution to this except to take it back to Iveco for reprogramming.

I am led to believe from my locksmith that there are two types of transponders generally put into cars and vans.

The first is a simple chip wtih a code which matches a code in the car / Van

The second is a chip which has a set of codes. They are read in order and the car / van remembers which one was used last. If you use the wrong code in the sequence then the car / van will ignore it and not let you start the engine.

The Iveco is unfortunately in the second group. If, like me, you snap your key, you can superglue a new key to the old and it works fine. The chip doesn't need to be "too" close to the barrel. Yes, it looks ugly, but it's much cheaper!

replace the crank shaft position sensor

check your distrubutor cap remove and clean