20 Most Recent 1986 Nissan King Cab Questions & Answers

0helpful
1answer
0helpful
3answers

Speedometer Cable or sensor

Yes you have a speedo cable. I know its been a long time but i just seen this looking for a speedo cable for my D21
1/20/2015 6:48:50 AM • 1986 Nissan King... • Answered on Jan 20, 2015
0helpful
2answers

Hard to get shifter into gear

Clutch need replacing?
12/1/2014 10:52:58 PM • 1986 Nissan King... • Answered on Dec 01, 2014
0helpful
2answers

No lights 1986 nissan

Check fuses, check light switch and relays. This sounds like a no power issue so check fuses first. The light switch turns on or activatves relays which the power or voltabe to the lights .
5/28/2014 11:27:03 AM • 1986 Nissan King... • Answered on May 28, 2014
0helpful
1answer

Nissan 720 z24 shot a few codes, idles decent, but sudden acceleration cuts out

Major sensor issues. Check the diagnostic codes. They should tell you the fixes needed
3/19/2014 5:57:41 PM • 1986 Nissan King... • Answered on Mar 19, 2014
0helpful
1answer

Oil light on

The light usually indicates that your engine oil is LOW. You should add engine oil (immediately) so that your engine doesn't seize up and your vehicle stops working (until you replace the engine). If you live/drive in cold climate, you can add 5W30 oil ... in the winter. Or use 10W30 .
3/3/2014 6:41:38 AM • 1986 Nissan King... • Answered on Mar 03, 2014
0answers
0helpful
2answers

Head bolt settings

1st - step; - 22 ft./lbs. 2nd - step; - 58 ft./lbs. 3rd - step, loosen all bolts completely; 4th - step; - 22 ft./lbs. 5th - step; - 54 ft./lbs.fig074.png
3/3/2013 7:21:02 AM • 1986 Nissan King... • Answered on Mar 03, 2013
0helpful
1answer

86 v6 nissan pu wont rev over 28.000 rpm

The following are the general instructions on the start of diagnosing any electronically controlled engine or transmission problem.

The engine and the automatic transmission (transmission control is only for automatics, engine is still computer controlled no matter the transmission type) in this vehicle are computer controlled and in most cases when a fault occurs a fault code is stored in the memory of the computer control module. There are exception to this, such as the Mass Airflow Meter and fuel pressure problems. What must be done is to have all the basic testing done such as a scan of the system for fault codes as well as a check with a live data scanner tool for engine functions that are not within range of normal, a trained technician is required to know what is correct and what isn't, then based on careful diagnostics done from a factory repair manual the correct part is replaced or the wiring repaired or the computer replaced (known as the PCM), which is very rarely the problem. Other basic checks must be done as well such as mechanical problems with the engine as well as engine state of tune and mileage on the engine. The transmission can have mechanical issues as well such as no gear engagement at all or a failed pump or other pressure related problems. Also engine mechanical problems can and do cause many drive-ability related problem such as rough idle and other symptoms.

10/26/2012 7:41:08 PM • 1986 Nissan King... • Answered on Oct 26, 2012
Not finding what you are looking for?
Cars & Trucks Logo

83 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

King Cab Nissan

  • King Cab Nissan

Most Popular Question

oil light

  • Cars & Trucks
Loading...