20 Most Recent
1989 Nissan Maxima - Page 9 Questions & Answers
1989 NISSAN MAXXIMA LOW HEAT IN CABIN
Could be a blocked heater core (the part inside the dash that the hot water runs thru), or the heater blend door motor not operating (the part that allows the air from the heater into the vents), or a broken blend door shaft, or something similar. Most of these would require a workshop to attend to them, although you could try flushing out the heater core, by removing those hoses you spoke about from the pipes they go onto at the firewall and directing water at a reasonable pressure (not high pressure like a steam cleaner) into one of the pipes to see if you get a whole lot of crud come out. This may or may not fix the problem and I recammend you take it to a garage and if cost is an issue just tell them you want it diagnosed, and to advise on a price to repair. Give them an upper limit on what you expect to pay for diagnosis as well.
1989 maxima no heat in vehicle
Put your hand on the heater hoses as close to the fire wall as possible find out if both hoses are hot.Do this when the vehicle is cold allow car to heat up with heater open and running.If both equaly hot then heater core at fault.If different check water supply to cold hose.
Factory alarm
it cannot be isabled trust me mine did the same but if you take it to a stereo place ask them to ground it and put in a cheap alarm system then it will never go off but you will still have a alarm system
1989 nissan maxima
you might be able to find it on google, but i'm sure that in the hayne's manual there are directions.
Transmission
this is caused by your torque converter inside your gearbox being faulty when this part goes wrong it is very rare that they can be fixed so if the worst may happen you will need a new torque converter however this can be an expensive part ask your local garage for a quote
Thermostat housing
yes it can however depending on the type of metal your block is made out of depends on weather it can be fixed in sum cases you can just weld the broken block but your engine block may have to be taken off to do the job speak to your local engineers and hopefully they can help you out more with the problem
Key Code
The dealership can cut you a new one based on the code if you provide the VIN number to the car, and your title/registration/photo ID (so you can prove you own the car and that you are who you say you are).
Have problems starting 1989 maxima
Jiggling the fues box and sometimes works, that means some connections are lossing. check the back of the fuse box to find out which one is lossing and fix it.
1995 3.0 engine. Where is the crankshaft (position) sensor?
In the 1995 Nissan X-Trail with a 3.0-liter engine, the crankshaft position sensor is typically located on the engine block. However, it's important to note that the 1995 X-Trail model was not available with a 3.0-liter engine. It's possible that you may be referring to a different Nissan model or engine.
To provide you with accurate information, please specify the correct Nissan model and engine.
Power locks fell into door
Remove door panel by prying out at the bottom. Follow around door and remove the panel retainering tabs. Push up on panel to remove from top of door. Now snap the window lock button assembly back in place.
How to fix 00 maxima
00 maximas don't have swirl control valves that feature wasn't added until 01 unless by some wierd chance your max was made after July in 00 and is cal spec
Not finding what you are looking for?