20 Most Recent 1994 Nissan Altima Questions & Answers

One of the blend door motors on the A/C Heater assembly may be stuck or defective or one of the linkage arms may have fallen off.Slide under the dash a bit and slide the temperature button.
You may have to take a panel or two off above the passenger/drivers feet area.
Can you see any movement on any linkage or locate the noise at one of the blend door motors?
You might just see a linkage arm off and you may be able to reattach it.

1994 Nissan... | Answered on May 28, 2017

1 Answer

1994 Altima will fire but not start on cold or wet days

It may have to do w that timing chain due to vacuum advance being off too.

1994 Nissan... | Answered on May 07, 2017

1 Answer

My 1997 Nissan Altima doesn't like to start, but when it does, it runs fine. Would this be a distributor cap?

not a distributor cap problem as any problems there results in misfiring, no start at all, back firing etc
have the fault codes read for a electronic sensor fault
( maf/vaf / baro /ambient temp sensors etc)

1994 Nissan... | Answered on Apr 14, 2017

0 Answers

1994 Nissan Altima speaker 2-way?

1994 Nissan... | Posted on Apr 01, 2017 | Be the first to answer

0 Answers

1994 Nissan Altima stalls while driving on road & cannot be started immediately but after 2 min it can be started without issue.

1994 Nissan... | Posted on Mar 13, 2017 | Be the first to answer

1 Answer

Maf sensor

was it a new maf fitted or a referbed unit
most new mafs sold only have a 6 month warranty

are there any other fault codes present or just the maf fault code

I agree with you a fault in the maf can make the car behave that way
the maf has a few functions with sensors in the unit

other sensors can also cause the engine to behave that way
02 sensor / faulty transmission solenoids and TPS

different car maker
i have just done a diode jump at the ECU
bypassing a faulty sensor in a maf
so far maf throws a fault code but no more problems

1994 Nissan... | Answered on Mar 01, 2017

1 Answer

My husband pulled a spark plug wire out of the cylinder and it was covered in oil

Hi,first of all you need to know if there is a spark on the plug,if there is,it could be that the car has worn valve sills,or it could have worn piston rings,you should try doing a compresion test this will give you a good idear what state the engine is in,a haynes maneul will help giud you,all the best.

1994 Nissan... | Answered on Mar 05, 2016

1 Answer

How to change 1994 altima fuel pump

Replacing fuel pump on a 1996 Nissan Altima - YouTube

? 3:39
https://www.youtube.com/watch?v=nnCmk9ZAr28
Mar 23, 2014 - Uploaded by Shogun Bug
Replacing fuel pump on a 1996 Nissan Altima ... I got the pump out and put the new fuel pump in but now my ...

1994 Nissan... | Answered on Jan 01, 2016

1 Answer

How i get my transmission to go in gear?

it might be the transmission kick down switch that is bad should have it serviced

1994 Nissan... | Answered on Dec 07, 2015

1 Answer

Need a location for the knock sensor

On the engine block, between the #2 and #3 injectors(in the middle). You gotta go from underneath.

1994 Nissan... | Answered on Oct 15, 2015

1 Answer

My 94 Nissan Altima ECU is giving code #21. This is for Ignition signal. Haynes manual says, "See dealer". It is also coding #11 - camshaft sensor.

Code 11 crankshaft position sensor or Camshaft position sensor. Code 21, Ignition Signal, Diagnostic Tree . Best to take to dealer for repairs and to remove codes, the codes do not mean the units are faulty ,just there is a fault, could be just a bad connection.

1994 Nissan... | Answered on May 13, 2015

2 Answers

Does anyone know what's the pression that should be applied to the head motor?

if you mean cylinder head bolts follow this link and click on torqu tables
http://www.speedwayautoparts.com/index35.htm

1994 Nissan... | Answered on Apr 17, 2015

1 Answer

94 Nissan Altima will turn over but not start. The dash and clock will not light up at all. Previous problems were minor but now no real fire. Has a good battery.

first check all fuses make sure they are good, check the ignition wire at the key see if you have power when the key turn on,

1994 Nissan... | Answered on Mar 27, 2015

0 Answers

94 Nissan Altima won't turn over will try. Is it a relay?

1994 Nissan... | Posted on Mar 27, 2015 | Be the first to answer

1 Answer

How do I test relay to see if it is bad? 1994 Nissan Altima turn over but not start. No lights on dash and no clock or blower for heater. Is this a fuse?

call you local auto parts store and ask if they can check you car out with a cen-tech trilangual code reader, this device will talk to the on board computer, troubleshoot and tell the auto parts person what fuse is bad and you will not waist a lot of time and money

1994 Nissan... | Answered on Mar 27, 2015

1 Answer