Top 20 1995 Nissan Maxima Questions & Answers


You need to provide more information, there are many things that could prevent it from working- not just a fuse. Is the fan blowing in the car? Does the compressor clutch engage? Have you done anything to the system lately?

1995 Nissan... | 17 views | 0 helpful votes


I take help from online websites that have this service like helping in repair some like reliable-store have instant help.. others are a bit slow which I don't prefer... rest is up to u.. U can also get free manuals

1995 Nissan... | 25 views | 0 helpful votes


Two relays must close. One for security system and one for neutral safety. Check both circuits. Is there a security light flashing?

0900c152800764b0-u3ryi4bjhkx0yvueqlscqy34-1-0.gif
Do It Yourself Diagnosis and Repair

1995 Nissan... | 124 views | 0 helpful votes


Here is the name of the cable you ask for:
Battery Cables with Leads .
-You can replace with the new one or just clean.
-Best way and safe to clean battery's corrosion.
-Use baking soda.
-Wet all area that you need to clean then shake baking soda onto it. Make sure all surface get it. let it soap for 5-10 minutes then use nylon brush to brush back and forward for couple minute then rinse with water. After dry use battery corrosion protection to spray on to it. So it will last for a while depend on how good it was cleaned.

Good luck and enjoy

Mai

1995 Nissan... | 63 views | 0 helpful votes


Try checking the harness to your fuel pump, run a ground wire somewhere onto gastank from body of vehicle but must be rust and paint free or a ground wont contact (dont weld or put screws into tanks maybe the edge or corner can be cleaned and a tiny hole - use a brass wire brush that wont spark eh, or if there is a leak in lines you are sucking air lol but that would be more sputtering and hard starting. that thing is old and inside tank rusty perhaps and sucking this rust into filter and another filter on fuel pump & pick-up tube if pump is inside the tank, some vehicles have a port under the back seat to access fuel pump & sending Unit. The fuel pump relay could be pitted so switch that with one of the others with same numbers,
there is a big steel ring around fuel pump *& sending unit access port to seal it and this area has to be cleaned so you tap the ring into unlock position tapping with hammer and brass punch so as not to spark, be extremely careful as rusty lines could break - once the ring is turned the sending unit will come out of tank being careful to not damage the float that is attached which runs to a rheostat to give you your fuel level.
once the fuel pump is out you can carefully disassemble and replace with a new or used pump from reputable used auto sales, but never pay 400 for complete sending unit that's for the rich & lazy.
when the fuel pump comes out put a rag in the hole as any spark is a boom! So, check filter at end of the pump and pick up tube and shake and tap and rust debris out of fuel pump can connect to a cheap 9 volt adapter (never the car battery (too many amps) but a 9-Volt rectangular battery is ok like the kind in a smoke detector!! or 9 volt DC power adapter with 300 milliwatts just for a few seconds to see if pump pumps, or perhaps in reverse for just a second or 2 to pump out old dirt but needs to be submerged in fuel to do so which is totally dangerous so ya not for everybody and be good to know the polarity and just brush the wires together for the first tests and I dont actually suggest all or any of this for anyone to actually do this as I have in the past but if you are brokea$$ and gotta, then just dont blame me for your stupidity of you make a mistake or deem this rediculous but this is backyard style.
just a few tips...
sounds very difficult but likely something simple.
\I would invest in the cheap bluetooth OBDII auto diagnostic tool on Ebay for 10. or so. Every car should have one and or everyone! Dont pay dealer 90$,
Good luck.
give us feedback if your issue is solved, that gives us incentive and ways to solve your problems, sorry im not so eloquant but try some of the simpler things first.

Thanks

1995 Nissan... | 134 views | 0 helpful votes


P0443,look at the evap control system pressure sensor,or the evap canister purge volume volume solinoid valve[the valve is stock open]hoses,,maybe the hoses are connected incorrectly..

1995 Nissan... | 406 views | 0 helpful votes


look at your crank sensor,,i think its faulthy.

1995 Nissan... | 422 views | 0 helpful votes


i'd say faulty gear position switch

1995 Nissan... | 93 views | 0 helpful votes


sending unit is bad or thermostat is stuck open

1995 Nissan... | 205 views | 0 helpful votes


V6 engines (VG30) renowned for breaking exhaust manifold studs. As to the pulley marks, looking at the engine from the pulley side, as the pulley rotates clockwise, the first mark up is TDC, the second is the timing mark for when the engine is running and you are using a strobe light.

1995 Nissan... | 143 views | 0 helpful votes


Hi, My advice would be to look for a wire going to the distributor then remove the wire that is part of old alarm system, you should only have one wire going to the distributor. Plugs should not be problem as it started at the dealers. Please leave me feed back Malcolm Campbell, crossflowspeed@hotmail.co.uk Thanks.

1995 Nissan... | 73 views | 0 helpful votes


Usually plastic bags that has been whipped up into the engine bay or the underside of the car and has been fused to the exhaust.

1995 Nissan... | 169 views | 0 helpful votes


Check a Haynes manual from AutoZone.

1995 Nissan... | 58 views | 0 helpful votes


check spark knock senser at front of oil pan

1995 Nissan... | 67 views | 0 helpful votes


-Not the spark plug that you just replaced.
-It could be bad crank, Cam., broken timing belt, bad ignition module or blown fuses.
-Check it out.

Good luck

Mai

1995 Nissan... | 36 views | 0 helpful votes


it could be a failing sensor, most common is the cam sensor, if its not reading sometimes it will give wrong signal, most come to do this when engine is hot.

1995 Nissan... | 95 views | 1 helpful votes


the problem is fuel related and nowhere else
it indicates a vacuum leak , either at the manifold , brake booster , transmission actuator hose/unit for the transmission or hoses that control under that dash
bad at stopping at light indicates that it is the brake booster
simple test is to put the hand brake on, start the engine and if it idles ok , put your foot on the brake
if still ok move vent controls ,
if with the foot on the brake it plays up , replace the brake booster

1995 Nissan... | 152 views | 0 helpful votes


Open the drivers door panel and locate the inside lock cylinder, there is an alarm switch that wrap around it with an electrical wire came out, it might also have another one on the passenger side in some other model . What it does is arm and disarm the alarm when you use the mechanical key and in some other model, it also lower the window when you disarm. The switch might pop out of place or deteriorated due to age. Good luck all.

1995 Nissan... | 310 views | 0 helpful votes


removing the can sensor and it fixes the problem indicates that you need to replace that sensor

1995 Nissan... | 204 views | 0 helpful votes

Not finding what you are looking for?
1995 Nissan Maxima Logo

1,541 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2000 Nissan Maxima
2000 Nissan Maxima

1,263 Questions

1996 Nissan Maxima
1996 Nissan Maxima

984 Questions

1997 Nissan Maxima
1997 Nissan Maxima

839 Questions

2004 Nissan Maxima
2004 Nissan Maxima

751 Questions

2001 Nissan Maxima
2001 Nissan Maxima

455 Questions

Top Nissan Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Maxima Nissan

  • Maxima Nissan

Most Popular Question

cause 1995

  • Cars & Trucks
Loading...