Top 20
1995 Nissan Maxima - Page 2 Questions & Answers
I have a 95 Maxima
Trying to clean the MAP sensor will damage it. Install a New Air filter and The Fuel filter, then replace the MAP sensor. Do not touch, or spray(compressed air or solvent) on the element when installing it. Have all of the OBD II Stored codes Deleted. Add a can of B&G 44K fuel additive to a full tank of fuel. The B&G is the best on the market, do not substitute. It is only available Through dealerships (Toyota). It will condition fuel pump and injectors. The ECU in your car is very dependable and rarely needs replacing. Always Replace cheapest parts first. Test drive the car and Then recheck The OBD II for new faults. The dimming of your lights before shut down was due to RPM of the engine dropping below 750 RPMs. Alternator will not produce voltage below 750 Rpms. 30 Amps at 14 Volts is required to run the engine.
Can i hook up an amp to my bose system
O assume you are wanting to add a sub as bose systems are already amplified. The short answer is ues, however most bose systems require special interface harnesses and may require complex wiring. This is best left to a qualified mobile electronics shop.
What number do you is for the tail light on the 95 nissan maxima
Depending on the manufacturer, there are a variety of numbers that identify this item as a part number. Best thing is to call your local dealer and talk to the parts dept. Then, tell them if they can look up the part you are searching for. Once they identified the part number, tell them if you can have them give it to you so that when you call back you can give it to them as a reference.
1995 nissan maxima alternator replacement
1995-98 Models
- Disconnect the negative battery terminal.
- Remove the splash guard on the right side of the vehicle.
- Loosen the alternator belt idler pulley.
- Slip the drive belt off the alternator pulley.
- Remove the four air conditioning compressor mounting bolts.
- Remove the radiator fan and fan shroud.
- Move the air conditioning compressor forward.
- Disconnect the alternator harness connector.
- Remove the alternator mounting bolts, and lower the alternator from the vehicle.
To install:
- Hold the alternator in place and install the mounting bolts.
- Plug in the alternator harness connector.
- Move the air conditioning compressor back into location.
- Install the radiator cooling fan and shroud.
- Install the air conditioning compressor mounting bolts.
- Place the drive belt on the alternator pulley.
- Tighten the drive belt to the proper tension with the idler pulley.
- Install the splash guard.
- Connect the negative battery terminal.
Proper belt tension is important. A belt that is too tight may cause alternator bearing failure; one that is too loose will cause a gradual battery discharge and/or belt slippage, resulting in belt breakage from overheating.
"Warning Lights" on the dashboard of "1995 Nissan Maxima"
The warning lights coming on with the key in the on position is normal. If the key is turned to the start position and the engine will not crank over, suspect an internal starter motor problem or lack of power to the starter solenoid. You can try tapping on the starter motor with a blunt object while someone holds the key in the crank position to see if it starts when this problem occurs. If it starts using this procedure, the starter motor will be defective
Windows, Locks, And speakers not working. No blown fuses
On some cars when you disconnect the battery for whatever reason certain electrical areas will not be restored to operation after the battery is reconnected. You need what they refer to as a radio code to restore radio and other circuits to operation. The code should be in car manual. If not contact the dealer for the radio code for your car.
Can't start car. How do I shut off alarm or valet switch?
If you don"t have the remote and alarm is going off , there are a few ways to get the alarm off . First make sure all doors are closed and hood and trunk as well go to the drivers door and use your key to lock and unlock the car the alarm should disarm if it does not work do the same on passenger door or trunk one should disarm it . All the locks have magnetic switches on them , they do break so if it doesn't work on one lock it should work on one of the others unless all are broke . Hope this helps you .
Wont pass emission test no engine light on
diesel or petrol? Is the engine worn....has it done lots of miles?
If there is black smoke coming out of the rear and it is diesel add a couple of infector cleaners to hald a tank of fuel and go out for a 50 mile high revving ride. Make sure your cambelt is ok before you try that one.
In a petrol vehicle do the same.
If theengine is not a very high mileage one and has been well cared for it might be that the vehicle only needs a tune up to pass emissions.
This work should be done by a good and experienced mechanic who has a knowledge of nissan, they will probably know the ins and outs of the engine and the ancilleries
GOOD LUCK
Not finding what you are looking for?