20 Most Recent 1992 Chevrolet Lumina Questions & Answers

If the signals come on, but don't flash, check & or replace your flasher, or swap it with hazard flasher if it's the same to confirm flasher is the problem. Hazard & blinkers are on serarate flashers.

Depending on the vehicle, there is probably a U shaped slide clip that holds the lock cylinder to the body of the vehicle. It simply slides onto the cylinder against the deck lid. It should have a lip on the opposite side of the U opening to grip in order to slide it off.

You need to have your power steering looked at. You can make sure the power steering fluid is full, first.

Could becaused by a few different thing's . Map sensor , idle air control valve , a vacuum leak . Having the vehicle's scan data viewed would probably pin point the problem . Do you know what scan data is ? Is what a professional tech uses to find problems . 084 Engine Mechanical Tests Scan Data for Vacuum Leak 007 Idle Speed Problems Scan Data for Idle These kind of test's are what seperate week end DIY'ER's from a professional tech.

Try changing the fuel filter, water trapped in it can freeze. Its a 92 and probably time for a fuel pump. They don't like water either.(Meythonol Fuel) Always change fuel filter when adding antifreeze to fuel

could be a dirty fuel inject problem run the fault code first to check for cam/crank position sensor problems or other electronic faults and go from there a dealer charging $80.00/ hr is cheap as where i am it is $145.00 /hr

Some pressure is normal, but this does seem excessive. Try new gas cap.

you have a faulty door latch switch. it does not know that the door has locked check your door functions manually that will give you a clue which side

the relay for the brake is not proper and the connection is not healthy so check the relay first which can rectify your problem

If you can get under the van and using a flash light look up to the bottom side of the hood. You will see a lever hooked into a rectangular loop. take a pair of plyers and pull on the wire to open or take a piece of round metal and have someone puch down on hood and you can push the hook for the hood

Hope this helps!

Usually when you get at the turn switch, you can use a jumper wire to bypass the turn switch and make the turn signals dance. If they won't work with the jumper, the problem isn't the turn switch. Maybe a problem with flasher or wiring issue in steering column? Did you check for voltage at the turn fuse? Goes hot with the key on. Use a test light to check for voltage.

Not the best picture for location. If you have another flasher for comparison it will help.