Top 20
1992 Mercedes-Benz Mercedes Benz 500 Class Questions & Answers
2004 eclass 500gear shift
Start up is in the starter/solenoid relay area.
Not moving in Drive could be trans fluid is too low, it has to be checked when warm(15 mins run) but as long as its well up the stick, cold, it should go. Has it got any safety switch to stop drive if park brake is on?
5/19/2014 10:02:52 PM •
1992...
•
128 views • 0 helpful votes
I REPLACED NEW BATERY ON
It sounds like a security system issue. The only solution is to contact a dealership for help with the code. It involves the on board computer system and has to be hooked up the the scanner at the dealership.
2/17/2011 6:25:49 AM •
1992...
•
202 views • 0 helpful votes
My 92 mercedes 500 sel
Check ASR system. Wheel sensors would be a good start because thats what the system checks for speed difference at the wheels. It reduces power to keep you straight on the road.
10/21/2010 3:40:42 AM •
1992...
•
654 views • 2 helpful votes
Ars light on
need more information what's the your car sl 500 or s500 and also need to know what time it's happen when first acceleration light comes on or while drive car some time it's comes on, other thing would like to know every time ignition off and start is the asr light off? if you give more information can be solve your problem,
10/16/2010 9:31:51 PM •
1992...
•
370 views • 1 helpful votes
Pleas tell me why my 92Mercedes 500sel
Your speedo may have a transducer on the side of the gearbox that sends electrical signals up to the speedo, if the transducer is faulty you will not have a speed reading on the speedo
hope this helps
bye the way, I have never had the pleasure to work on a mercedes but I would imagine that it will be similar to most modern cars
6/26/2010 1:40:19 AM •
1992...
•
489 views • 0 helpful votes
My 1992 mercedes 500 sel runs rough once started..
Lots of things to check. From 1993-1995 the US made car compaies use biodegradable insulation on it wire which ages with engine heat and then shorts so check that first. It has an upper harness for engine and lower for charging and starter. Then a real tune up is next coils, cap, rotor and wires. Once youve done that fuel system is next on the list fuel filter and fuel pressure.
4/30/2010 1:03:11 PM •
1992...
•
612 views • 0 helpful votes
Why does my 1992 MB 500sel not always start on the
The 2 things to help start at first try are the coolant sensor and the cold start valve. If the coolant sensor is bad , it give an erratic resistance so the cold start valve could not open to assist the start. If the cold start is not open then you have not had the assist from the cold start valve. Good luck.
3/11/2010 2:33:25 PM •
1992...
•
310 views • 0 helpful votes
92 500sel ... #1 piston not firing. Changed
You can go to most any autoparts store and have the codes scanned too for free that may give you codes to help point you to the right direction right away. Try checking your distributer cap and wires. You can check for continuity with a volt meter for your wires and then look under the dis. cap for any posible corrosion. Another thing is to pull that plug of the cylinders that are not firing (should be the ones that when you pull the spark plug wire no change to engine RPM is noted) see if they are black/white. Black means too much gas(rich) and white is not enough gas (lean).
8/22/2009 1:55:24 PM •
1992...
•
160 views • 0 helpful votes
Lack of power seems to be a problem with the
When was the last time plugs, plug wires cap/s rotor/s and coilc were replaced? I would try that first. Also you have the starting year when mercedes was told by the US to use biodegradable insulation that was "cooked" by engine compartment heat. Try buymbparts.com for engine wiring harness and lower engine wiring harness to replace them.
8/10/2009 11:03:41 PM •
1992...
•
106 views • 0 helpful votes
Can you help me set the valve timing on my 129 v8
hi,clarification 129.066 engine 119.960 or 129.067 engine 119.972 same v8 engine but different specification,post your engine number,you need 2 mm valve timing using a dial gauge,ty
3/21/2009 9:30:30 PM •
1992...
•
306 views • 1 helpful votes
My 1992 500 wont go pass 25-30miles per hour
i would say check brakes first, make sure you dont have a sticking caliper. take off breaks press in caliper, if it wont go in replace the caliper, i would say your brake system would be making the sticking feeling and not the transmission from how you make it sound.
12/2/2008 2:39:27 AM •
1992...
•
120 views • 0 helpful votes
1994 500s model ...radio
there are 2 slots find a feeler gauge or something flat undo 1 side at a time pull staight out
7/3/2008 2:21:15 PM •
1992...
•
97 views • 0 helpful votes
Not finding what you are looking for?