1991 Nissan Maxima - Answered Questions & Fixed issues


-Have you connect all electrical lines to all injectors...?
-If yes. all are connected then do the following test:
-Disable the fuel pump by removing the fuel pump fuse.
-Disconnect all electrical line from the injectors.
-Use noid light tester to connect to each line then crank about 2-3
seconds to see any light. Do one after the others to all 6.
-If all lines have light then now remove all spark plug, leave it open then crank the engine for 6-7 time to clear all gas inside.
-install plug back into. connect all injector line.
Now start. You should be good to go.
Good luck

Mai

1991 Nissan... | Answered on Dec 26, 2017 | 88 views


Check for any air leaks between the mass airflow meter and the engine like the rubber being split on the air intake boots etc.. I once had a toyota that would do the same thing and the fix for that was to flush the coolant passages in the throttle body, worth a try. Also you said you replaced the TPS. If the TPS has slotted holes you must set the minimum TPS volts or that can also cause idling issues. Clean the throttle body as well.

1991 Nissan... | Answered on Dec 24, 2017 | 15 views


while clicking is happening place your hand on the heater blower motor and you will feel it coming from there. change the blower fan.

1991 Nissan... | Answered on Apr 08, 2017 | 71 views


1991 Nissan/Datsun Maxima 3.0L FI SOHC 6cyl

The Coolant Temperature Sensoris located:

Under hood, center, front engine area, mounted in driver side front of cylinder head.Here's a link to what it look's like.

Duralast Coolant Temperature Sensor SU405 Read Reviews on Duralast SU405

1991 Nissan... | Answered on Apr 07, 2017 | 154 views


There is usually a dimmer switch for the dash lights near the left side of the dash behind the steering wheel. Sometimes that can get bumped when you get in the car and turn the dash lights completely off.

1991 Nissan... | Answered on Oct 27, 2015 | 223 views


If the starter works and there is no spark at the ignition coil, replace it. Check your center electrode wire too. A new distributor cap and rotor may be in order as well. If that doesn't fix it, your distributor is shot.

1991 Nissan... | Answered on Mar 12, 2015 | 65 views


you have a transmission problem your forward clutches may have to change,did you check the shift cable by the neutral switch if all those area check ok the transmission have to be repaired

1991 Nissan... | Answered on Feb 25, 2015 | 223 views


Pull the bulb back out and look in the plug. They get corroded and the tabs will spread apart and/ or break off. Bend them back if they are there, replace it , if not.. If it looks good, you need to use an ohm meter and check continuity of the tabs to the wire. They usually break close to the plugs.

1991 Nissan... | Answered on Jan 03, 2015 | 121 views


If dealer will not provide, there are books available which have nothing but vacuum diagrams. FYI, most newer cars have basic vacuum diagrams on a sticker somewhere under the hood. Dirt often prevents one from seeing it.

1991 Nissan... | Answered on Dec 18, 2014 | 671 views


Don't attempt it. It is not for the DIYer. There are very detailed procedures to follow and getting the timing right is is tricky. If you do attempt it buy a good manual and follow it closely.

1991 Nissan... | Answered on Aug 19, 2014 | 73 views


Remove the lamp housing to get to them,
if you can not see & reach from under the hood

1991 Nissan... | Answered on Jul 30, 2014 | 70 views


major mechanical job, best advice i can give is get a good workshop manual for your vehicle as this will explain step by step . It would take me ,and others , hours to type the info you need here, you will also need some specialist tools , engine hoist etc, good luck and keep me posted if you wish

1991 Nissan... | Answered on May 11, 2014 | 56 views


IAC sensor could be bad.

1991 Nissan... | Answered on Nov 20, 2013 | 202 views


timing is off a little turn distributer a hair if it gets worse go the other way maybe injector cleaner in gas tank

1991 Nissan... | Answered on Aug 15, 2013 | 184 views


Best guess is O2 sensor is reading too much unburned fue in the exhaust for some reason and leaning out the fuel flow to compensate. Runs when you throw more throttle at it but leans out as you try to hold steady speed. Should throw a code though.

1991 Nissan... | Answered on Apr 25, 2013 | 248 views


most older over seas cars it will the only way to find out for sure is call a dearer and ask about a timing belt and if its an interference motor

1991 Nissan... | Answered on Apr 17, 2013 | 62 views


Have someone in the car when you lock it from outside. The person that is inside needs to unlock the car for you. This deactivates the anti theft and it should start. Let me know if this works.

1991 Nissan... | Answered on Apr 02, 2013 | 174 views


You may have over tightened the belt or the alignment may be out

1991 Nissan... | Answered on Mar 20, 2013 | 318 views

Not finding what you are looking for?
1991 Nissan Maxima Logo

307 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2000 Nissan Maxima
2000 Nissan Maxima

1,263 Questions

1995 Nissan Maxima
1995 Nissan Maxima

1,089 Questions

1996 Nissan Maxima
1996 Nissan Maxima

984 Questions

1997 Nissan Maxima
1997 Nissan Maxima

839 Questions

2004 Nissan Maxima
2004 Nissan Maxima

751 Questions

Top Nissan Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...