20 Most Recent 1993 Nissan Pickup Questions & Answers

I NEED TO NO WHERE ALL THE VACUM LINES HOOK UP TO ON A 1989 NISSAN Z24 ENG

On the intake 0.0008 or 0.0020 (it's in between these 2)

this is for the stem to guide clearance. (for the intake)

The Exhaust 0.0018 to 0.0030 stem to guide clearance.

it should be under the car close to the driver side door. if you can't see it trace it from the fuel tank it should be attached to the fuel line. if you have the repolacement in your hand you will know what you're looking for

there are 4 wires go to alternator
2 white wires go to battery
1 black wire goes to ground
1 yellow/black goes to bulb check relay
starter has only two wires
the big one goes to the battery and the small one goes to ignition system. you can not mix the terminals because the size of the studs on the starter

I think you have checked the major points, but if the transmision hung loose long enough it could damage the U-joints and motor mounts. The easy way to check the u-joint is to put the truck on ramps and put it in gear, then get under the truck and attempt to turn the drive line. If the drive line move 1/4 turn or more the u-joints are damaged. The motor mounts can be checked when the motor is running. Standing over the motor while someone else revs the motor you can see the motor move from side to side, more than three inch movement could indicate loose or broken mount. The clutch may be the culprit but I would check these first.

the mark to the right of the pully will be 0 .. it will be like this. 8 6 4 2 0

hi if you think the four wheel drive it not being use it very likely that the link that engages the four wheel it rusty or the gear shift inside the gear box will not slide by some wearing abstraction caused by wear and tear

Inside door handle should have some screws that need to be removed and the window crank will have a c-clip behind it . or some you have to pop the cover off the window crank

Possibly a bad connection on the positive side coming from the battery or a weak ground. Check where the leads join the terminal clamps. Has the battery been verified as good? It doesn't take a lot of amps to run lights but it does to turn over the engine. Jump starting it does not require a fully charged battery.

Have an alignment done. It requires specialized equipment

Can you do a compression test? There may be something amiss with the piston or valve.. and it's usually the exhaust valve that has burnt/split, allowing compression to be kicked straight out of the exhaust. The symptom of a burnt/split exhaust valve is akin to a misfiring spark plug

Nissan Pickup For the easy solution download the pdf file

Could be bad speed sensor.

where can i find assembly diagram for nissan vanette c22 manual transmission

missing can be from vacuum leaks, faulty injectors , low fuel pressure, faulty coil, ignition module, low voltage from faulty alternator or bad battery supplying less than required voltage to the electrical system

Here's a link on replacing your alternator. Repair Guides Engine Electrical Alternator AutoZone com

open the tailgate, you should see the screws behind that assembly http://www.carcarekiosk.com/video/1995_Nissan_Pickup_XE_3.0L_V6_Extended_Cab_Pickup/lights/tail_light video is just an illustration i'm attaching a pdf copy of the service manual so you can see the actual drawing on page BF-7 http://www.nicoclub.com/FSM/Hardbody/1988%20d21%20nissan%20navara%20pathfinder%20terrano%20service%20manual/Section%20BF.pdf

open the hood and see