20 Most Recent 1996 Pontiac Bonneville SE CA Value - Page 2 Questions & Answers

fuel pump relay, check or replace

ignition module

need help heat is not working

the heat is not coming out the vents 2005 chv impala

The blinking light means that your car has a engine miss and should be checked now. Take it to an autozone and they will connect it to a scanner and retrieve a code. This will indicate what type of problem you have. The traction light tells you that your cars transmission is now in limp in mode because of the miss and is not responding normally to reduce damage.

ur losen fuel pressure--car is old and worns stuf like intake gaskets or plastic fuel hoses etc--hav a xperiencd mech not a dealer inspect vehicle or du a fuel pres test

The security, antitheft, or passlock light is a visual indication that something in the car's antitheft system is failing. In most GM cars and trucks there is a hidden system that most people are unaware even exists. From the moment you put your key in the ignition, there begins a constant line of communication between your key's security chip or transponder, to the ignition's lock cylinder, and then to the car's TDM (Theft Deterrent Module). These 3 parts are in CONSTANT communication. If the key is in the ignition, then these parts are sending signals to each other. The security light illuminates when that signal gets broken, even just for a second. When the signal breaks, the car misinterperates this as an attempt at theft and goes into antitheft mode. The car thinks its being stolen or hotwired because it is not getting that signal from YOUR specific key. This is why the security light turns on and shuts down your vehicle. This link may help you find ways to bypass this or fix it yourself.http://vatspasslockpasskeysecurityhelp.yolasite.com/

A slow cranking engine can be caused by; bad alternator brushes, bad alternator coil, faulty starter, faulty solenoid etc-----------------------------------------------------------------------------------Renault CAN Clip

may be you should make a diagnostic and you can do it in a garage or you can do it by yourself if you want to do it by yourself you need some tools and you can find some good ones here: chinasinoy.com

Auto parts specialist will have a catalogue for fan belts/drive belts to suit you model car

Try checking low brake fluid also might need front brakes that can cause low fluid

Jack up your car and make sure you have jackstands or something safe to support the car while it's in the air, look under the car on your sarter you'll have 2 bolts on the starter take the loose and your starter should come down. Take your positve and negative wires off of the starter and replace it the same way you took it off make before you start working on it that your cables are disconnected from your battery.

Check for runout in your wheel bearing hubs. You can also hit your e brake lightly and see if it shakes then. If it does, it is in the rear rotors which will also warp.

You will need to remove the engine's valve cover at the rear of engine to remove the blower motor, also replace the blower motor resistor while you are in there.

you need to buy haynes repair it will show and tell you how to remove and install intake manifold, you will mechanic basic tool set and a torque wrench.