1996 Pontiac Bonneville SE CA Value - Answered Questions & Fixed issues
Water Pump??
You need to find out exactly where it is coming from in order to figure out what needs repairing. Choices are usually either a hose in the cooling system or a gasket on the intact manifold.
2/9/2018 2:35:23 AM •
1996 Pontiac...
•
Answered
on Feb 09, 2018
•
36 views
My fuel pump and windows dont work is it a relay
These two problems are not usually related. You have seperate relays for each. You would need to check for power to the fuel pump and if it is present and the pump is not powering up then the fuel pump is probably bad. If it is not receiving power to the pump check the wiring and the relay.
2/20/2016 6:30:00 PM •
1996 Pontiac...
•
Answered
on Feb 20, 2016
•
336 views
I need torque sequence for rod bearing caps
There is no sequence for the rod caps Since there are only 2 bolts per cap you only have to snug up each bolt then apply half the listed torque value to each cap bolt. then continue back and forth on them until the end torque value is applied to both bolts.
8/22/2015 10:14:49 PM •
1996 Pontiac...
•
Answered
on Aug 22, 2015
•
573 views
INSTALL BLOWER MOTOR ON A 1996 BONNEVILLE
Hey Brian, I did find every thing you need at auto zone library, its all free and no spam, just log in and list your vehicle then go to repair guides, then open repair help now go to chassis electrical . and look to left and click on blower motor .
hope this helps , good luck.
Woody
2/26/2015 8:38:22 PM •
1996 Pontiac...
•
Answered
on Feb 26, 2015
•
161 views
Need to replace freeze plug
Replace them all at the same time, otherwise you'll be back under the engine again and again. There is a tool you can get at an auto parts store that helps do the job easier.
12/6/2014 4:31:21 AM •
1996 Pontiac...
•
Answered
on Dec 06, 2014
•
97 views
Engine shut down while driving
2 different issues, Engine shutting off usually with your car is the ignition module under the coils, Windows usually is a broken wire in between the door and the body jam, inside the rubber tube. Might be suprised to find a couple more wires broken
10/24/2014 1:27:15 PM •
1996 Pontiac...
•
Answered
on Oct 24, 2014
•
264 views
What is a code PO106
The code is pointing to the MAP sensor or barometric pressure sensor, and the sensor most of the time is on the intake manifold or on the fire wall connected by a small hose to the intake manifold
6/23/2014 12:34:25 AM •
1996 Pontiac...
•
Answered
on Jun 23, 2014
•
104 views
Cd player cds
check the format of the burned cd against the format required by the cd player.
12/29/2013 4:46:07 AM •
1996 Pontiac...
•
Answered
on Dec 29, 2013
•
110 views
Not finding what you are looking for?