Top 20 2002 Chevrolet Tracker Questions & Answers

you wil probably need to replace the entire switch assembly which will include other windows switches aswell. but the assembly will be reasonably easy to remove from the door and swap out (you may or may not need to remove part or all of the door trim to do so). just remember to put the wires back exactly where they came from on the new unit.

Should be on the right rear valve cover depending on the exact engine size if its a 4.3 or 3800 ect. hope this helps.

Let's get this if we have this right ! When you turn the key to the start position ,the starter engages an spin's the engine around , But does not Start ? If that is the case ,why on god's green earth did you take the starter off an have it checked ? An if it doesn't spin the engine over ,how do you know it doesn't have spark ? From your posting it clearly sounds like you don't have any diagnostic skill's , so do youself a favor an have a professional shop check it out .

This place is a good place to start. http://www.bbbind.com/free_tsb.html Hope this helps

could be a bad solenoid in the trans.

I think I would start by changing the broken TPS with a new one.

My info says 73.8 ft lbs. 2wd

Injector maybe ! What's that cylinders comprssion ?

Drive as is will cost a lot to fix this problem, keep eye on it.

Try adjusting the neutral safety switch on the side of the transmission.

Note the diagram. Maybe problem with shift solenoid?

Cylinder Misfire Detected Random Cylinders http://www.autocodes.com/p0300_chevrolet.html

Get a Chilton manual from any auto parts store to get a step by step instruction with diagrams.

The light switch can over ride the DRL. If it doesn't. You have 3 possibilities. The switch s bad, the light sensor is bad, or the BCM is bad or not receiving signals. Have the codes read for the BCM.. Takes a scanner. Not a code reader.

Voltage drop test starting system , could be a bad cable . Starter Voltage Drop

You have to remove the instrument cluster from the vehicle and the bulbs are replaces from the backside.

there is a small plate attached in the engine compartment that has the paint colour code stamped into it The 54U may be the colour and you may have to go to a service dealer to have it explained.

Haynes manual from your local auto parts store will tell you.

It should be in the glove box on that plastic label, if not their try the front door where the hinges are if you still cant find it take your vin number and go to a GM dealer.

Your O2 censer should be under the car at the junction from the manifold to the exhaust pipe, it's connected to the censer lead.