2002 Chevrolet Tracker - Answered Questions & Fixed issues
How to replace drivers door power window switch on 2002 chevy tracker
you wil probably need to replace the entire switch assembly which will include other windows switches aswell. but the assembly will be reasonably easy to remove from the door and swap out (you may or may not need to remove part or all of the door trim to do so). just remember to put the wires back exactly where they came from on the new unit.
2002 will not start
Let's get this if we have this right ! When you turn the key to the start position ,the starter engages an spin's the engine around , But does not Start ? If that is the case ,why on god's green earth did you take the starter off an have it checked ? An if it doesn't spin the engine over ,how do you know it doesn't have spark ? From your posting it clearly sounds like you don't have any diagnostic skill's , so do youself a favor an have a professional shop check it out .
How do you install a engine starter on a 2002 chevy tracker 2.0 liter engine with four wheel drive ?
- Disconnect the negative battery cable.
- Remove the air cleaner hose.
- Disconnect the starter solenoid electrical connector.
- Remove the retaining nut and positive battery cable (3) from the starter solenoid.
- The starter motor on manual transmission equipped vehicles are secured with 2 bolts. The starter motor on automatic transmission equipped vehicles are secured with a lower bolt and an upper nut and bolt. Remove the upper mounting bolt (1) and the negative battery cable from the starter motor assembly.
- Remove the lower mounting bolt (1) and the starter motor assembly from the vehicle.
- Install the starter motor assembly to the vehicle.
- Install the lower mounting bolt.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
- Install the upper mounting bolt and the negative battery cable.
Tighten
Tighten the starter motor assembly mounting bolts (1) to 30 N·m (22 lb ft).
- Connect the positive battery cable (3) to the starter solenoid. Secure with one nut.
Tighten
Tighten the starter solenoid nut to 10 N·m (89 lb in).
- Connect the starter solenoid electrical connector.
- Install the air cleaner hose.
- Connect the negative battery cable.
Tighten
Tighten the negative battery cable-to-negative battery terminal retainer to 15 N·m (11 lb ft).
Not finding what you are looking for?