20 Most Recent 1995 GMC Jimmy Questions & Answers

95 GMC jimmy thats leaking oil, cracked remote oil line to filter

Get this manual online at www.reliable-store.com and get complete guide on whether to repair or not, service it, and how to repair etc, along with wiring diagrams, electrical diagrams, torque specs, error codes, everything.

1995 GMC Jimmy | Answered on Mar 13, 2018

1 Answer

1995 gm tuck 7.4L o2 sensor contantly reads over

Use a gage and check proper fuel pressure. My info for the 7.4L engine says, 26--32 psi, so if it is right in the middle somewhere, should be ok. If pressure too high, check out the return side of the fuel system.
If you have a leaking fuel injector, fix it.

1995 GMC Jimmy | Answered on Feb 07, 2018

1 Answer

2001 gmc jimmy overheating

Change your motor fan and change your temperature sensor.

1995 GMC Jimmy | Answered on Jan 31, 2018

1 Answer

Have a 1995 Jimmy 4.3W MPFI with OBD2. Error is P0122 TPS sensor and have replaced that. Idles between 700 and 1200. Have replaced injector spider,fuel presure reg,EGR,new gasket, fuel pressure is abo

Some of the older GMC ECM's keep the error code for some time. You may have to have it reset and see if the code comes back. I had a Yukon that had a check engine lite on for about 6 months and it finally went off last week!

1995 GMC Jimmy | Answered on Dec 12, 2017

1 Answer

1998 Rodeo Izusu Front Bumper is off track.

just get the service and repair manual from the given link but first go to the link read the description then buy and i am sure you will took help from the mechanic after buying this factory manual http://toolsnyou.com/

1995 GMC Jimmy | Answered on Dec 12, 2017

1 Answer

I have a 2000 chevrolet blazer zr2 that the rear

Go to online store reliable they have repair manuals I am sure you will get the solution. Here's the link Best Manuals

1995 GMC Jimmy | Answered on Dec 06, 2017

0 Answers

I have a Valet Model 552T that was installed

1995 GMC Jimmy | Posted on Oct 19, 2017 | Be the first to answer

0 Answers

4wd actuator cable won't hook in axle

1995 GMC Jimmy | Posted on Sep 09, 2017 | Be the first to answer

1 Answer

1995 GMC Jimmy will just cut off while driving it.

If something is draining the battery you have a parasitic draw on the electrical system . There are a couple ways of testing for this . GM insturment clusters can cause this problem as well as a module not powering down . Really don't think electrical wire burnt problem . The car would catch fire an burn up.
The BEST Way TO Perform Parasitic Draw Test

How To Perform Parasitic Draw Test EricTheCarGuy

The Trainer 27 3 Ways Of Finding The Cause Of Key Off Battery Drain...

1995 GMC Jimmy | Answered on Aug 07, 2017

1 Answer

I have a 95 gmc

bad switch?

1995 GMC Jimmy | Answered on Jul 28, 2017

1 Answer

1995 GMC Jimmy trans shift problem- but no check engine light at any stage of the problem . I can get the transmission to shift from 1-2, 2-3, but only by giving full throttle and then letting my foot

Mine does the same thing, Have not found a fix.

1995 GMC Jimmy | Answered on Jul 23, 2017

1 Answer

95 gmc jimmy transmission my reverse doesnt work

Replacing internal parts on that old a transmission is a waste of money. I would replace it with a certified rrebuilt.

1995 GMC Jimmy | Answered on Jul 03, 2017

1 Answer

1995 GMC Jimmy brake lights not working

Brake lights run through the hazzard switch. There are known problems with this, and the multifunction switch. You may need to buy a new hazzard switch and OR the multifunction switch. Before you do that, check the pigtail that goes into the brake switch up by the fender, make sure it's not shorting out up there. Happened to me!

1995 GMC Jimmy | Answered on May 08, 2017

1 Answer

How to start my 95 gmc jimmy without a key for it.

Replace the ignition lock cylinder with a new one that you do have a key for or go to the dealer prove to them that you do own the car and they will contact GM and make a new key to fit your vehicle.

1995 GMC Jimmy | Answered on May 05, 2017

0 Answers

Can not find the starter wire for 1995 gmc jimmy vortec v6

1995 GMC Jimmy | Posted on Mar 21, 2017 | Be the first to answer

0 Answers

Seems like a short circuit in 95 gmc jimmy

1995 GMC Jimmy | Posted on Mar 14, 2017 | Be the first to answer

1 Answer

95 AUTOMATIC GMC JIMMY (2WD) 6 CYL 4.3 VORTEX WILL NOT REVERSE

Nope.

1995 GMC Jimmy | Answered on Mar 12, 2017

1 Answer

I have 1995 gmc jimmy 4l60e trans long gates shift from 1 to 2

I am old school and do not know if vacum modulator still used , check if hose still ok . Modulators used to be cheap .
Hugh

1995 GMC Jimmy | Answered on Mar 10, 2017

1 Answer

1995 GMC Jimmy will not start.

It sounds like you have a fuel problem (too lean). This problem is probably with the injector spider assembly, a common problem with high mileage Jimmys. Early versions of this spider do not use individually controlled poppets - just one injector that feeds each of the six cylinders in sequence under control of the ECM. If you can get it started, try a high strength injector cleaner in the gas tank. Also, the fuel pressure reading must be within normal range when you turn ignition on and then while trying to start the engine, and if not, the fuel regulator is faulty. You could also have a malfunctioning injector. In either case, you should try replacing the entire spider assembly.
Replacing the faulty O2 sensor is also a good idea. This engine starts in open loop mode, and after it warms up it tries to go to closed loop and the ECM will attempt to use the O2 sensors in it's calculation for fuel delivery. If one or more of the sensors are contaminated, this will drive the ECM crazy.

1995 GMC Jimmy | Answered on Mar 07, 2017

1 Answer