1995 GMC Jimmy - Page 3 - Answered Questions & Fixed issues
How do I clean spider injector?
check to see what the codes are for and test and repair what needs to be done concerning the codes. to clean the spider injection it has to be put on a fuel system cleaner machine to supply sufficient pressure to clean the injectors.
8/23/2014 5:09:28 PM •
1995 GMC Jimmy
•
Answered
on Aug 23, 2014
•
135 views
Parking brake cable broke
Its very easy to replace, first you need to follow the cable from the handbrake to identify the one that has broken. You should be able to replace it as its quite simple. Disconnect the cable and then pull it through, to replace start from inside the vehicle and thread it through. Then just connect the same way you disconnected
8/1/2014 11:41:44 PM •
1995 GMC Jimmy
•
Answered
on Aug 01, 2014
•
51 views
Why does it shake whenever i let off the gas and shakes real bad when i apply my brakes
If when applying the brakes the steering wheel shakes then your front rotors are warped and at the least need resurfaced and most likely the brake pads replaced. But more likely the rotors are too thin which has allowed them to overheat and warp which causes the shaking. In this case new rotors and pads are in order. If when braking tou feel the shaking in the seat of your pants then most likely the rear brakes are the issue. Same problem as the front, warpage, but your rear brakes are most likely drums. Again, possible resurfacing and new shoes; but more likely new drums and brake shoes.
But I wonder? Did this vibrating just start all of a sudden or maybe after a near accident requiring you to brake very heavily and possibly overheat the brakes. Or my main concern, to keep this from happening again, after pulling some type of trailer that you intend on pulling again. Pulling a trailer without its own brakes puts a much heavier load on your trucks brakes and just repairing them won't keep it from happening again if you ARE pulling a trailer. Higher quality rotors/pads/drums/ and brake shoes can help but if the trailer is too heavy for the truck nothing but installing brakes on the trailer or a lighter trailer will stop you from warping them again.
Lastly, in general when you let off the gas and the whole vehicle shakes the driveshaft/u-joints are common causes. Same with the steering wheel if it shakes when letting off the gas, but only on a 4x4 or AWD vehicle. So check your driveshafts and u-joints and make sure they are tight. But unless you find something obvious there I would wait until you have the brakes sorted out and see if that doesn't stop all the shaking.
Good luck!
12/14/2014 8:15:27 AM •
1995 GMC Jimmy
•
Answered
on Dec 14, 2014
•
2,664 views
Crank torque settings for fiat siena 1.2 mpi
the crank has many spots to torque
the mains.
the rod caps
the front pulley
the flyhweel.
a fiat GMC, well , we dont have those but you can get any FSM for car and its all there.
1995 FIAT? 1.2L MPI.
6/15/2014 3:02:33 PM •
1995 GMC Jimmy
•
Answered
on Jun 15, 2014
•
136 views
1996 GMC Suburban...Courtesy lights stay on and
96 Jimmy Check the SMT surface mount technology, referring to circuit boards.
WOW, listen under the steer wheel is a panel
drop it down on the panels left side as it comes down is a small black plastic box left of the diagnosis jack with I don't know 5 or 6 wires going to it, wires come from the left hand corner above the emer brake pedal. Plugged in lights on ,,out lights off. Then have the unit tested. or replace. If there was ever a power surge the caps could have blown.
5/25/2014 12:30:18 AM •
1995 GMC Jimmy
•
Answered
on May 25, 2014
•
535 views
Where is the egr valve on 95 jimmy
It is the cylindrical object shown at the tip of this arrow. Google "GMC EGR valve" to see what the valve looks like by itself.
5/22/2014 11:14:38 PM •
1995 GMC Jimmy
•
Answered
on May 22, 2014
•
160 views
Stuck 4wd low
I'm not for sure but my suv has low and to get out of it u have to put the trans. in N wait a few then move the switch to 2 wheel and it switches. hope this helps
4/5/2014 4:11:51 AM •
1995 GMC Jimmy
•
Answered
on Apr 05, 2014
•
314 views
Not finding what you are looking for?