20 Most Recent
- Page 5 Questions & Answers
Cannot open drivers door from the inside on 2001
1. The Metal Rod connecting the inside door handle to the door mechanism is most likely disconected either at:
a. The inside door handle
b. The connection on the door mechanism.
2. The Door Mechanism is not operating correctly.
You should be able to see the door mechanism and the connections. I sometimes use a poskeyt mrror and flashlight to see the mechanism.
A. Check the connections and try moving the metal bar back and forth attempting to open the door.
B. If this does not work: then attempt spraying WD40 into the door mechanism and re-attempt.
C If this does not work: then remove the mechanism and check the inside door connection mechanics.
on Apr 11, 2015
I have a 2001 Dodge Dakota with 3.9, Im getting a no bus ,I can communicate with my pcm,but can't communicate with other modules. Do anyone have a suggestions to what might be my problem?
TO START BEST TO SEE IF THE PCI BUSS IS IN COMPLETE FAILURE OR IN INDIVIDUAL MODULE NO RESPONSE. THESE ARE THE TWO FAILURE MODES OF THE PCI BUSS IN YOUR YEAR VEHICLE BY CHRYSLER CORP. . SO DO ANY OF THE POSSIBLE 11 MODULES COMMUNICATE TO THE SCAN TOOL? IF YOU WERE USING THE DRBIII FIRST THING UNDER NO RESPONSE FROM ANY MODULE WOULD BE TO PERFORM A MODULE SCAN TO DETERMINE IF ONLY ONE MODULE IS NOT ON BUSS OR IS THERE NO RESPONSE ON THE BUSS AT ALL. NOW IF YOUR SCANTOOL IS AFTERMARKET THERE IS A ALTERNATE WAY TO DETERMINE STATUS OF BUSS THIS WOULD BE TO TAKE A SENSITIVE DVOM AND ON THE ALDL PROBE THE PCI BUSS WIRE AND CHECK FOR VOLTAGE THE BUSS PLUSES BETWEEN 0 AND7.5 VOLTS IF YOU SEE A CONTINUOUS ZERO VOLT STATE THEN YOU NOW KNOW THAT THE ENTIRE BUSS IS DOWN THAT MEAN THAT EACH MODULE WILL HAVE A SET DIAGNOSTIC PROCEDURE THAT WILL NEED TO BE RUN THROUGH. IF YOU SEE 7.5VOLT THEN THE BUSS IS ACTIVE AND ONLY THE MODULES THAT HAVE NO RESPONSE WILL NEED ATTENTION . DATA CIRCUIT WIRES ARE YELLOW WITH A PURPLE TRACE OR PURPLE WITH A YELLOW TRACE AND JUST BEHIND THE ALDL IS THE JUNCTION CONNECTOR WERE ALL THE COM LINES GO INTO ONE FOR SCAN TOOL CONNECTION . REMEMBER A NO RESPONSE RECORD IN REGARDS TO SCANTOOL DATA THIS WILL BE SHOWN IF THE VEHICLE IN NOT EQUIPPED WITH SAID MODULE. SO DON'T GET LOST CHASING THINGS THAT AREN'T THERE HOPE THIS WILL HELP. I WILL CHECK BACK LATER TO SEE IF YOU POST ANY ANSWERS TO THOSE QUESTION WHICH WILL HELP ME FINE TUNE MY RECOMMENDATIONS FOR REPAIR STRATEGIES.
on Feb 11, 2015
Not finding what you are looking for?