20 Most Recent 2005 GMC Sierra Denali - Page 7 Questions & Answers


Hi! I strongly suggest that you replace the suspensions. They are surely worn causing it to bounce left and right. Hope this helps and thank you for using FixYa!

GMC Denali Cars... | Answered on Oct 31, 2010


hello, if your car has a catalitic convertor, it might damage him but if is a diesel engine, the posibilities to create damage is minimum. good luck!

GMC Denali Cars... | Answered on Oct 24, 2010


What year is your vehicle,motor size and what model do you have and I will be able to help you.

GMC Denali Cars... | Answered on Oct 19, 2010


I think that the best solution will be to get the manual for the vehicle as the diagram may be included there and not online for some reason.

I looked on Autozone.com and on my online resource which is based on Chilton and Haynes but bodywork information was not listed.

I wish you luck on finding information on how to put the nose of a 1999 Yukon, Denali together.

GMC Denali Cars... | Answered on Oct 11, 2010


Something is obstructing the sensor

GMC Denali Cars... | Answered on Oct 06, 2010


Ck your fuses

GMC Denali Cars... | Answered on Oct 02, 2010


possibly 4 things 1 bad ignition coil heating up then breaking down,2 clogged fuel filter,3 weak fuel pump,4 bad throttle position sensor or map sensor to check sensors simply put on hand held scanner and look for codes. replace fuel filter replace coil pack along with tune up plugs wires put fuel pressure gauge to see if fuel pump is working properly

GMC Denali Cars... | Answered on Sep 18, 2010


have you changed the tires

GMC Denali Cars... | Answered on Sep 16, 2010


You should check the fuses. sometimes the rear doors are on a different fuse than front. could also be a break in the wire where it passes through one of the rear doors.

GMC Denali Cars... | Answered on Sep 14, 2010


It is located along side of the driver's side frame rail, almost directly under the rear seat. Hope this helps!

GMC Denali Cars... | Answered on Sep 04, 2010


With a single serpentine belt most gm models have a belt tensioner which has a small square hole in the tensioner. You put a 3/8 inch drive ratchet in the hole and pull up or push down to release the tension off the belt. Once you have released the tension pull belt off of one pulley and you can ease up on ratchet and take ratchet out.

GMC Denali Cars... | Answered on Aug 28, 2010


AXLE NUT TORQUE IS 177 FT LBS.

GMC Denali Cars... | Answered on Aug 25, 2010


Hi, Sounds like your actuater for your heater box damper is bad. Its munted under the dash over the center hump. you will have to remove the cover that goes the length of the heater box to find it. The actuater motor should move back and forth with the temp knob going from cold to hot.

GMC Denali Cars... | Answered on Aug 25, 2010


Hi,Sounds like your resister for your blower motor is shorted. this is mounted under the passenger side of the heater box where the blower motor is. This resister board has a reley mounted on it for high speed operation. very easy to change around 40 bucks at auto zone.

GMC Denali Cars... | Answered on Aug 25, 2010


TRY THIS INSTRUCTION..GUIDE.c55f5e5.png

GMC Denali Cars... | Answered on Aug 15, 2010


Need to know what model and year. Off the top of my head it is a fuel pump or filter.

GMC Denali Cars... | Answered on Aug 14, 2010


it holds 6.0 qts if you change filter to, also there should be a reset button for the tire pressure in the fuse box on the driver side of the dash.

GMC Denali Cars... | Answered on Aug 10, 2010


Hi,

Firstly, has this engine you are fitting this turbo kit too had a turbo on it before?

Also can I have the model and size of the engine?

This is a big job, and I need full details of the engine.

Thanks

Jason

GMC Denali Cars... | Answered on Jul 19, 2010


Hi.

Here the procedure
  • Trun off the engine.
  • Put the ignition key in RUN position.
  • Press and release the accelerator pedal in full and slowly for three times within 5 seconds. I
  • A reset message should flash to indicate that the system is resetting.
  • Turn the key to lock position.

Regards.

GMC Denali Cars... | Answered on May 27, 2010

Not finding what you are looking for?
Cars & Trucks Logo

71 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top GMC Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Denali GMC

  • Denali GMC

Most Popular Question

2005 gmc yukon denali other

  • Cars & Trucks
Loading...