Top 20
2005 GMC Sierra Denali - Page 3 Questions & Answers
The chain jumped the gears.
u may need 2 replace the timing gears as well old gears may have worn teeth.i had same prblem with a chev mtr fitted a chain&gear set fixed it right up. ps make sure u use a new chain
My 2005 Yukon Denali shakes
Yes i would think so.These new vehicles are suppose to go 100,000 miles before it gets a tune-up and yours is there.I would like the sparkplugs are culprit.
2006 envoy stops when the
Do you mean that the engine shuts off when you come to a stop? If so, you need to have the throttle body cleaned, grime build up in the throttle body will cause a lean condition. This shutting off happens especially with the AC on.
The traction active light pops
The Traction Control is part of the ABS system. This sound like a possible speed sensor harness problem (pretty common on GMC vehicles). There are two wire harness that plug into each front wheel speed sensors and sometimes, when turn the wheel these harnesses flex with wheel movement, thus causing a erratic speed signal to the computer which in turns causes the light to come on, because the computer thinks one wheel is spinning.
Keep in mind that the only way to know for sure is to have the ABS scanned for codes, so, what needs to be done from here is to have the fault codes checked in the ABS/Traction computer to see if any are set, any shop or dealer can do this and a local parts store might check fault codes for you free of charge as I have hard of before.
Then it can be diagnosed as to what is at fault and then repaired. If no codes are set then the vehicle needs driven with the scan tool plugged into the vehicle to observe the wheel speed sensor signals, if a wheel speed sensor signal is found not reading close to the other wheel speed sensor signals then this is the suspect sensor and the connections need checked at the sensor as well as the wiring to make sure it is OK.
Most of the time it ends up being a faulty wheel speed sensor and needs replaced.
Hope this helps.
My denali ran out of
You should be able to hear the pump run only when the key is first turned on for a second or 2. I would say the fuel pump is out. this happens when you run the gas out it can prematurely wear out the pump impeller. If you can hear the pump fire up check the fuel pressure at the fuel rail. the pressure for most GMs should be at least 33lbs to 50lbs if it is below this pinch off the return fuel line and recheck pressure. if under you have a bad fuel pump.
Thanks for using FixYa
Hope this helps you out
Went to store car would
Either you left a light on for a while, commonly headlights and dome lights, or the alternator is bad.
Get a jump start and run the engine for a while, it should charge the battery if it was just you left the lights on.
If the car won't stay running, take a trip to Autozone and have them test your alternator (don't worry, it's free and can be done in the car if you would rather tow the car than try to remove the alternator).
When do i change the
Hello,
The question you are asking indicates you wanna know the ideal time to change the engine oil of your yukon.
The ideal time recommended by the manufacturer is after every 6months which is the time for the general servicing of the engine.
To achieve optimum perfomance of your car,it is recommended you carry out other actions,which includes the cleaning of the spark pluggs,oil filter and the fuel filter.
Thank you for using fixya.
I have a 2005 GMC
try new light bulbs, I have seen both burn out at the same time, or could be a bad dimmer switch.
Hi. How difficult is
AS LONG AS YOU BORROW OR RENT A SPRING COMPRESSOR KIT ITS NOT TO BAD A JOB CAUTION SPRINGS HAVE A LOT OF TENSION WHEN COMMPRESSED.
Were is the low a/c
If you follow the lines from the copressor it should be where the line changes from a rubber hose to a metal line when you find them both the hose that comes with a recharge kit will only fit the low pressure side port.
Not finding what you are looking for?
