20 Most Recent 1995 GMC Sonoma - Page 3 Questions & Answers

If you do a google search for 1995 gmc Sonoma fuse box diagram you'll find what you need

theres 2 black headlight retainers that u pull up from inside under hood compartment,headlight housing will come out and bulbs will be accessible.

Use a heat gun.

No, only a 1994-1995 engine will work.

Great.

Im sure your 95 is no different then my 01 sonoma 4x4 u shouldn't need a cherry picker to do the engine mounts a small block of wood and a floor jack to support the engine from underneath and take a little bit of the load off the mount should work you dont have to lift the engine out to do them its not easy this way but is possible and cost less money working for a gm parts department and a former tech you would be spending and average of 75 to 100 an hour labor wise depending on what shop u take it to and what shop labor rates at like near you I would estimate an easy 2 hours labor but it all goes by book time thats or determined at the shops

put a jack under motor to support the motor then replace. Might want to put a 2x4 and some rags or blanket between motor and jack to prevent damage

This could be anywhere in the drive-line. Process of elimination would be the best approach. From your symptoms it sounds like the bad vibration is noticed at low speeds. There are many moving parts within this system. Were there and recent repairs performed? New tires could cause a vibration, if the tread is aggressive. Damaged wheel-bearings, defective components inside the rear differential (suspect low fluid level, damaged ring and pinion or bearings), defective U-joints, or internal transmission failure. You didn't mention if the truck was 2wd or 4wd. If the vehicle is a 4X4 then you will need to inspect the transfer case, the U-joints in the output shaft, and the front wheel bearings. I'm not sure how far you want to go with the diagnostics. Please write back if you have other questions or to give an update to how the repair is going, good luck.

Like to other guy said, give it a tuneup. Also try SEAFOAM to clean carb up of slug. Also check to make sure the butter fly for the choke has not come loose, causing it the choke it down. Failed choke pull-off.

Trans shouldn't make it backfire,are you sure the dist. cap didn't hit the firewall when the trans came out and get damaged?

Timing Chain worn out ?