20 Most Recent
1987 Pontiac Safari Questions & Answers
2004 pontiac gran prix gt. car is running fine and
Yes there could be.But just cause the vehicle is running fine does not mean there is nothing wrong.It is just something that does not effect the way the vehicle runs.If you have the codes checked then you will probably have fuel level sensor code and possibly other codes.Auto Zone will check your codes for free.Good luck.
How to reset check engine light on nissan minivan
Hi..my name is Keith..and i dont know what year your minivan is..but if its an 80's model..you can remove the ground wire from the battery and wait 2 or 3 minutes and hook it back up..and it will clear the computer..on the 90's models..just take it to and autoparts store..like AutoZone or AdvanceAuto..and they will read the code and turn the light out for you..for free..i hope this has helped
Reset check engine light
Disconnect the battery for a few minutes. This should clear the code. Unless you have fixed the problem that set the code it will come on again.
Windshield wiper doesnt work
hii..ya u have to replace it with the new
one.Since it is frozen u can't do anything
with that.once u replace it with the new one
it will start working.Other than replacing the
wiper u have nothing to do.
thank u..
I am having problems finding parts for a 1900
Safari VAN maybe? instead of wagon. Then you would be looking for Astro van by chev. The years are still going to be the problem, you will need to get as close as possible for the interior parts - radio and such. As far as exterior parts-? Oh I just re-read your years you have posted, you might want to correct that- I don't think they made a 1900 model :-)
I got a 09 pontiac g6 wont start.there is no crank no clicks when i turn the ignition on but the engine light is on
You have know idea how the starting system works , an with the engine light on your best bet would be to have it towed to a qualified repair shop .
When the ignition switch is turned to the Start position, the body control module (BCM) receives battery voltage on the ignition 1 voltage circuit, and less than 5 volts on the off/run/crank voltage circuit. The BCM supplies voltage to energize the RUN/CRANK Relay 32. The BCM sends a high speed GMLAN serial data message to the engine control module (ECM) that the key is in the start position. The ECM receives the message from the BCM, and also receives a serial data message from the transmission control module (TCM) containing the shift lever position. If the shift lever is in Park or Neutral when ignition switch is turned to Start, the ECM supplies voltage to the START Relay 31. The START relay supplies voltage to the S terminal of the starter solenoid, through the 30 A STRTR Fuse 26, in order to crank the engine.
Firing order 2007 pontiac g5 2.2
Standing in front of car looking at the engine, cylinder layout is from left to right > 1--2--3--4 .... So the number one cylinder will be the one that is closest to the 'passenger' side fender.
Firing order is 1 4 3 2
Diagram 2006 Pontiac montana
copy and paste https://www.repairprocedures.com/service-manual/document/2005/pontiac/montana-sv6-awd/engine/drive-belt-replacement/2829_866_18767_142376_12_1506919.html
Not finding what you are looking for?