20 Most Recent
2002 Chevrolet Silverado 2500HD Questions & Answers
2002 Chevy Silverado 2500HD. Light green trailer
Did you check for voltage at backup lamp fuse, use a test light. The actual diagram I copied was larger than this and easier to read. This must be a site issue, common to fixya. You could even use a long piece of jumper wire from battery voltage to light green trailer wire, to see if lamp will light. It would'nt hurt to use inline fuse, for testing. If lamp still won't work, maybe problem with trailer wiring. You could even use jumper wire to bypass the connector itself, same color wire?
Replacing pcv valve
driver side valve cover in the back of the cover. if it even has one, sometimes the cover has been replaced with a later style that uses a baffle instead of a pcv
What's on TBC 2B fuse?
incorrectly wired radio would cause problem.it would be the wire that is suppose to connect for dimming lights looks like a ground but is not has a yellow or a white stripe with black on it.use it as a ground and it will blow the fuse.
My 2002 2500HD Silverado diesel wont engage the
if you had the rear wheels still on the ground in 4WD and it never drove the vehicle off the jacks or stands , you have a problem in the transfer case
in other words the transfer case is not selecting WD
A/C is not working in my 2002 Chevy 2500. I looked
First get the gas checked to see if you have enough left to run on , if you don't have any gas showing it won't run the compressor ps go into your kwik fit garage and ask them to hook the A/C up to there machine and thay will tell you if the vehicle is leaking , empty and refill it
Need advice on how to
I just replaced mine today and the easiest for me was to come up from the bottom.
then just follow your diagram.
Bleed brakes bleeder
I do believe you have to put your truck on a scanner to bleed the brakes properly. I have done it a few times to get the pedal back up. After some one else has worked on them. Usually it's because the ABS pump was run dry. But check for fluid around the brake booster, it will be wet and eating the paint off it. Replace the master cylinder first. Bleed, and if you still have the problem. Get it on a scanner.
Not finding what you are looking for?