20 Most Recent
1996 Chevrolet S-10 Pickup - Page 9 Questions & Answers
'96 Chevy S10, 2.2L - when in OD under load (up a hill) it shudders and rpm increases about 200 rpm....it does not do it in drive, only in over-drive
HelloThe engine
and automatic transmission in this vehicles drive train
are fully electronically controlled by a computer called the PCM
(Power Train Control Module). Whenever a problem like this occurs the
computer stores a record of the problem (there are of course some
exceptions to this, like the fuel pump, engine coolant temperature
sensor and MAF sensor for instance) in the form of a fault code in
its memory, to read these fault codes you must have the systems
memory scanned with a special tool. Once the fault code(s) are read
you then must perform the appropriate diagnostic testing to find and
resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A
TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR
HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM
Fuse box 1995 s/10 truck
car-parts.com has many used parts. I like their site but don't work for them. Location: in dash behind end cap on driver side. anything else?
Where in detail, is the orifice tube located, thanks
The tube is located at the high pressure inlet tube of the AC evaporator core at the rear of The engine compartment, the AC line that is small and high pressure goes to the connection point, remove the line after recovering the charge and inside is the tube.
Fuel relay
Hi there:According with the manual, you will need to check Position 9 on fuse box located in driver's end instrument panel.
Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.Thank you for using FixYa, have a nice day.
U joint\how do you replace
I would suggest a universal joint,drive shaft & balancing,place of businessIf you want to buy tool ,you can,for thatYou can use your vise, as people have fora centurySome animals hammer them apart
96 s10 with 2.2 4 cyl. got code 1406 which is egr
pintle position on EGR valve is incorrect if voltages are correct on EGR connector replace EGR valve if voltage readings are wrong at connector replace ECM both are found on ebay for under 75 bucks
Not finding what you are looking for?