20 Most Recent
2004 Chevrolet Express - Page 3 Questions & Answers
The belt is loose after changing alternator? It is
You have to put the belt on correctly,that is obviousYou draw a picture before you take it off,if you have none on a label on vehAlternator was only new item,i would assumethere is adjustment there.Tensionser don't fail often or cause a noticableloose condition
Security light on and van keeps cutting off
The security light comes on or stays on when the module does not "see" the correct chip in the key. Normally the system only works when you crank the engine, not after it is running. So if the light is coming on after the engine is running, and the engine also quits, I would look for an electrical problem with the key switch or the computer.
When dose a timing belt need to be replaced on a
This van has a timing chain, which should last for the life of the engine. The LS engines, which I'm guessing you have one of the 4.8,5.3,or 6.0L, use a high quality roller timing chain that is long-lasting, and won't give you issues. Also, having roller lifters, the camshaft puts less resistance on the timing chain, so the combination of a strong chain coupled with less resistance, makes for a reliable chain.
2004 chevy express van codes p0894
P0894 Transmission SlippingP1258 Engine got Hot
P1516 Throttle Actuator Control (TAC)Chevrolet Tahoe vehicles may experience a performance issue where they
will not go over 15MPH. The vehicle may appear to be in "limp-in" mode,
giving just enough power to get you to a shop.
The
codes indicate a problem with the throttle position sensor circuits and
throttle actuator performance. Do NOT start replacing parts. Shops
report a pattern failure in the electrical harness to these sensors.
Chevrolet has issued a revised replacement harness to correct the
problem. The original connector was prone to vibration and broken wires
that disrupted the signal to the PCM and put the vehicle into reduced
power mode.
Not finding what you are looking for?