20 Most Recent 2004 Chevrolet Express - Page 6 Questions & Answers


get into the oil change where it tells you what percent of oil life is left before change,then hold the reset button by the readout for 5+sec till it goes to 0 percent oil life use

2004 Chevrolet... | Answered on Feb 05, 2012


HAVE YOU ALREADY CHECKED THE FUSES...IT MAY BE A SHORT IN IT AND ITS ON ITS WAY OUT, OR MAYBE THE WIRING CONNECTED TO YOUR LIGHTS MAYBE LOOSE.

2004 Chevrolet... | Answered on Jan 12, 2012


The question is what color is the fluid. If it is yellowish and oily its going to be power steering fluid. If its red or or green and watery its coolant the only other thing would be gas or windsheild washer fluid. Check front driverside brakeline as well just to be safe

2004 Chevrolet... | Answered on Jan 05, 2012


That is what oxyecetelene torches are made for. Many of the bolts on your vehicle have a type of "glue" or "thread-locker" on the bolt threads. They can break off in the bolt hole if you try to get them off with brute force. Heating the bolt with a torch will cause the glue to soften and the bolt will probably come right out.

2004 Chevrolet... | Answered on Nov 24, 2011


I presume you are trying to REPLACE the hub assembly? If so, you do not have to worry much about dammaging it. Simply take the three bolts out of the inboard side of the steering knuckle and beat it with a large hammer.

If your van is equiped with All-Wheel Drive, you must remove the large nut from the axle first to do this. Then the axle can be pushed in far enough to gt clearance to get the bolts out of the steering knuckle that hold the bearing assembly. Two-Wheel Drive is much easier.

It is also recommended that you disconnect the wheel speed sensor wire harness before trying to get the hub loose. Damage to the vehicle harness can result if the bearing comes out suddenly and pulls on the cable.

2004 Chevrolet... | Answered on Nov 19, 2011


check battery as it may be dead or alternator may be going bad. to check alternator, start engine, remove lead from battery. if it dies, then the alternator is no good.

2004 Chevrolet... | Answered on Nov 17, 2011


Did you have a problem with that before??..Its always a good rule of thumb to change the thermostat when you change the waterpump..But if you had no problem with it before than it might still have some air in the system..Check see if you have any bleeder screws to let the air out..Usually located around the thermostat or near the waterpump

2004 Chevrolet... | Answered on Sep 11, 2011


Continually push the brake pedal to set the brakes. (With park brake off). Brakes are self adjusting and will adjust to correct position.

2004 Chevrolet... | Answered on Aug 18, 2011


try shimming the starter

2004 Chevrolet... | Answered on Mar 28, 2011


You sure can.

2004 Chevrolet... | Answered on Mar 14, 2011

Not finding what you are looking for?

336 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Express Chevrolet

  • Express Chevrolet

Most Popular Question

security light van keeps cutting off

  • Cars & Trucks
Loading...