20 Most Recent
2006 Chevrolet Blazer - Page 5 Questions & Answers
2004 chevy blazer
The light staying on while driving is due to one of the door jamb switches is malfunctioned and more than likely going to be the driver door. For the reason being is that's the door that's mostly used than any other on the vehicle. If memory serves me correctly, the switch is located on the inside the door at the lock actuator. As for the reason you door locks situation, there are many reasons for that. I hope this helps you with your light problem. Jesus loves you, John 3:16-17 (KJV)
Diagram of stereo wiring in a 1997 Chevy S-10 Blazer
Hi there:Check this on 1998 Chevrolet S10 Blazer Car Stereo Radio Wiring Diagram:Car Radio Constant 12v+ Wire: OrangeCar Radio Switched 12v+ Wire: Dark GreenCar Radio Ground Wire: BlackCar Radio Illumination Wire: GrayCar Stereo Dimmer Wire: Violet/WhiteCar Stereo Antenna Trigger: N/ACar Stereo Amp Trigger Wire: N/ACar Stereo Amplifier Location: N/AFront Speakers Size: N/AFront Speakers Location: N/ALeft Front Speaker Positive Wire (+): TanLeft Front Speaker Negative Wire (-): GrayRight Front Speaker Positive Wire (+): Light GreenRight Front Speaker Negative Wire (-): Dark GreenRear Speakers Size: N/ARear Speakers Location: N/ALeft Rear Speaker Positive Wire (+): BrownLeft Rear Speaker Negative Wire (-): YellowRight Rear Speaker Positive Wire (+): Dark BlueRight Rear Speaker Negative Wire (-): Light BlueHope this helps; also keep in mind that your feedback is important
and I`ll appreciate your time and consideration if you leave some
testimonial comment about this answer.Thank you for using FixYa, have a nice day.
My 2003 chevy blazer engine vibrate's
Could be a
half DOZEN major issues...
Hello Eddie Redding,
The FIRST things you want to check are
FIRE & fuel to each cylinder...
(
spark plugs and
fuel injectors )...
Once upon a time when "MECHANICS" worried
about the mechanicals of an engine...
IF a cylinder
was getting
fire & fuel then
COMPRESSION ...
( valve & ring performance ) would be NEXT on
the list... finally followed by
compression testing
and
BEARING clearances the
VIBRATION damper
(harmonic balancer)...
would finish the most common investigations...
FIRST Looking for "
DEAD-CYLINDERS"
Then getting exotic...
(I'm just saying)
Carnac the Magnificent
Unlocking a delco rds radio
Check your owners manual - there may be a default code and instructions.. However, many GM entertainment systems are locked to the VIN and you will probably need a dealer to reset it.
Replace headlight assembly Chevy cruze
This is an easy fix. There are 2 bolts surrounding the bottom of the assembly ( these are bracket type) and 2 right up top. Remove 3 inner fender well screws t15 if i remember correctly, remove the bumper facia, access bottom 2. Remove 2 from top, comes right out, remove bulbs, (connectors if needed) and replace.
Certified GM tech here.
Traction control night and brake light on 2008 trailblazer
First, check to see if your ABS and your TCS fuses are good. A lot of times, if both lights come on, it senses a failure in the braking system. Your vehicle will disable the abs if it finds a problem in the braking system, hence the red brake light/hand brake light coming on in the dash. Get a code scanner that also reads the abs module. You could have a bad wheel sensor, which is tied to your TCS and your ABS system. Either that, or you ABS module could be bad.
Not finding what you are looking for?