20 Most Recent 2000 Chevrolet Silverado 1500 Questions & Answers


This year of truck did have issues with rear disc brakes. Quality of pads is extremely critical. Go with the AC Delco pads and rotors to eleviate some of the issue. Make sure that the slide pins are liberally lubricated and move freely or drag will cause excessive heat to occur. Let me know if you need anything else.

2000 Chevrolet... | Answered on Nov 08, 2019


Open the bleeder screw and have a coffee break. Re-tighten screw.

2000 Chevrolet... | Answered on Sep 12, 2019


Did you hook up a professional scan tool , check sensor data to the PCM - engine computer ?

2000 Chevrolet... | Answered on Jun 20, 2019


Try pumping the brakes 3 or 4 times with the truck running in 'park'.

2000 Chevrolet... | Answered on Nov 24, 2018


The noise is caused by the axle button being worn out, this lets the axle move back and forth and clunk, this is a unique problem with C clip retained axles, it is a noise issue but will not fail and cause any more damage, in order to fix it you must have the axles pulled and the diff carrier checked for excess wear where the axle retainning C clip rides, if the carrier is ok then replace the axles.

2000 Chevrolet... | Answered on Oct 23, 2018


I have a 99 Silverado with the 8.6 3.73 rear diff. Is the torque specs for the yoke the same as a GMC at 270 ft lbs?

2000 Chevrolet... | Answered on Sep 24, 2018


My personal suggestion
would be to try www.reliable-store.com instead. much better info on all vehicles, complete details, and they also have live assistance feature

2000 Chevrolet... | Answered on Mar 08, 2018


did you check the fluid level? check for leaks?

2000 Chevrolet... | Answered on Feb 12, 2018


I think there is a wiring connector in the harness that may be loose or corroded. Trace wires from back to front.

2000 Chevrolet... | Answered on Feb 10, 2018


There are two vent/purge valves - one on the engine that takes vapor from the gas tank and cycles it into the intake manifold. The other one is connected by a hose to the vapor canister. I don't know which one you bought, but it can't hurt to replace both - the one that fails most often is the one connected to the canister and is usually mounted under the vehicle at the back. It often fails due to road contamination getting into the solenoid.

2000 Chevrolet... | Answered on Dec 21, 2017


Visit the on-line store, known as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem.
2001 CHEVROLET SILVERADO 1500 PICKUP REPAIR MANUAL

2000 Chevrolet... | Answered on Dec 18, 2017


Make and model, year, engine, transmission? 2wd/4wd, ever been wrecked, etc.
could be drivetrain parts such as c.v. or U joints.
could be fuel system clog somewhere.
could be a bad sensor.
We will need more detailed information.

2000 Chevrolet... | Answered on Nov 02, 2017


It sounds like you have a ground problem. Have you checked to see that the "new" battery is fully charged? Have you checked to see if the starter motor is getting current when you try to start the truck? Have you checked to see if the battery cables and terminals are corroded, or the cables themselves corroded at any point? You also might have an ignition switch problem due to age or use. You also might have a computer problem that is keeping the circuits from connecting properly. If you have a OBD II scanning tool, it might well tell you exactly where the problem is. Scanners are inexpensive and available almost everywhere. I bought mine through Amazon for less than $25 including shipping.

2000 Chevrolet... | Answered on Oct 26, 2017


for 4wl need to be stopped and put in neutral or park it wont actuate while driving [ blinking light indicates failure to engage ] 4wd hi can do while driving --if fails also then check and test for actuator sticking --control module --or transfer case failure

2000 Chevrolet... | Answered on Oct 19, 2017


Remove plugs and check compression, maybe burnt valve, unseated valve

2000 Chevrolet... | Answered on Aug 21, 2017


indicates injector problems and possible low fuel pressure
run the fault codes to check for EVAP and blocked cat converters

2000 Chevrolet... | Answered on Jul 20, 2017


If the transmission isn't shifting out of second, it's in "limp in" mode and there will be a trouble code stored in the computer. Start by getting the trouble code instead of trying to guess is a certain wire is the problem

2000 Chevrolet... | Answered on Jun 28, 2017


Hey RPG, There is a sensor on the side of the output shaft (Speedo).. Mine had become covered with metal crud and would not work,, pulled it out, cleaned it,..(replace the o-ring on the sensor!!) and it ran fine.. This might not work for you, but it did for me. Next.. take it too O'Reilly's, Auto Zone, or Advance Auto and ask the to scan you truck for a trouble code..(free) and see what turns up.. Good Luck..
https://shop.advanceautoparts.com/
Home Page Reilly Auto Parts
Save 20 On Online Ship To Home Orders Of 100 Or More

2000 Chevrolet... | Answered on Jun 27, 2017

Not finding what you are looking for?
Cars & Trucks Logo

1,730 questions posted

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Silverado 1500 Chevrolet

  • Silverado 1500 Chevrolet

Most Popular Question

new rear brakes locked up e brake seems

  • Cars & Trucks
Loading...