20 Most Recent 2000 Chevrolet Silverado 1500 - Page 4 Questions & Answers

there should be 4 to six screws around the cluster setup connecting the clear plastic cover to a black or dark color plastic piece connected to the cover unscrew those screws and disconnect the wiring clips from the back of the cluster

check fuel pressure..

Hello,
I hope this helps.







Thank You,
Roy

P0758 Chevrolet P0758 Chevrolet - 2-3 Shift Solenoid Circuit Electrical Possible causes - Low transmission fluid level - Dirty transmission fluid - Faulty 2-3 Shift Solenoid Valve - 2-3 Shift Solenoid Valve harness or connectors - 2-3 Shift Solenoid Valve circuit is open or shorted What does this mean? When is the code detected? When the Powertrain Control Module (PCM) detects a continuous open, short to ground or short to power in the 2-3 Shift Solenoid (SS) valve circuit, then DTC P0758 sets. Possible symptoms - Engine Light ON (or Service Engine Soon Warning Light) - Transmission will not shift gears P0758 Chevrolet Description The 2-3 Shift Solenoid (SS) valve controls the fluid flow acting on the 2-3 shift valves. The 2-3 SS valve is a normally-open exhaust valve that is used with the 1-2 SS valve in order to allow four different shifting combinations. The solenoid attaches to the control valve body within the transmission. The Powertrain Control Module (PCM) controls the solenoid by providing the ground path. Read more: http://engine-codes.com/p0758_chevrolet.html#ixzz3kcwzXFmK

that is because this is a either a linkage problem to shift column on transmission or just maybe the transmission has to be replaced. maybe all you need is a shift kit. try that ok?

you cant pack your wheel bearings they are a sealed hub if hub is bad will need to replace the whole unit

What do your brakes have to do with it not starting? Is your battery good? If so, maybe your starter is bad. Those are the first two things to check. Start with the battery.

Here's a video on replacing your antenna. How To Remove Install Radio Antenna 2000 06 Chevy Suburban Tahoe

Could be dirty throttle blade sticking open such that IAC can't do its job and mix is too lean too start.

how many miles on truck?

sounds like its time to rebuild it including a new shift valve body

Its most likely the switch if all bulbs and fuses are good

To Troubleshoot Transfercase stuck in 4wd issue.Click the link below and follow the details: http://www.allcarhelp.com/2015/04/transfer-case-stuck-in-4-wheel-drive.html This will help. Thanks.

sounds like a crank sensor

Have your ignition module checked, my car would start and drive and would go dead after a few miles and would not start until it cooled down, turned out to be the ignition module that eventually went bad and would not start at all.

My advice is to look at ignition loom under the bonnet sounds like water is getting in remove all electrical connectors spray with a water repelant spray also carfully check wiring for breaks in protcective cover make sure the ignition is not tracking to earth look for a blue spark jumping from plug lead/ignition.

If it is making a noise in park it may just be the linkage out of adjustment.