20 Most Recent 2005 Chevrolet Silverado 1500 2WD - Page 7 Questions & Answers

Misfire is usually a plug or wire gone bad. Check your plugs and wires and replace any fouled plugs or damaged wires and that should resolve the issue. If it doesn't then you will have to look at the Coil pack and Crank Position sensor.

Sounds like a loose connector, bad ground,bad motor, or corrosion in one of the connectors. When it's working check to see if all the speeds work. If they do then I suspect it to be a grounding issue, or main power going into the selector switch. If you've been messing in the dash like installing an aftermarket radio or something like that. Something could have come loose. Hope this helps.

Bad bulb left rear.

remove grill ck horns with jumper wires ck plug for power, if horns work .if horns dont work with jumpers replace . if no power ck fuse if good relay for signal and power if no signal when horn pushed either horn switch in airbag ,or cable reel witch need cked with special srs tools .

Either you blew the blower fuse, or caused one of the resistor coils to break.I would look for another connector from a junkyard, or a new one if you can find one, and splice it in in place of the burnt one. Is it melted pretty bad? If not too bad, you may be able to just wrap it with electrical tape. But pull out the resistor again to see if it is alright.Good luck.