20 Most Recent
2005 Chevrolet Silverado 1500 2WD - Page 9 Questions & Answers
I have a po449 code on my 05 chevy silverado what
hi there
this code is for evap vent solenoid you can pick one up at your locall dealer or auto parts store after installing it i would reccomend that you run a hose up the transmission tunnel toi keep dirt and debris from clogging it up again thank you and have a great day hope this helps you
I dont have power to
Have you checked the fuel pump relay? usually located near the fuse box.
All power leads installed correctly after pump replaced?
Reduced engine power
Less power usually indicates a ignition timing problem or in less common cases a clogged fuel filter or clogged breather holes in fuel cap (tank is sucked vacuum).
When there's unusual engine noise - stop the car and contact someone who can diagnose the extra sound.
2005 Chevy Silverado single cab.
already
first, find another mechanic-really, there could still be other reasons for your issues (bad electrical connection, security system, crank sensor, ecm harness/connector or ecm itself) but throwing parts at the problem is expensive, foolish and frustrating-another mechanic will have a fresh perspective, and you are having no success with the one your are spending all that money with-your vehicle is NOT that old and should not be difficult to diagnose.
Missing have had new plugs
Before you go all out and buy an ECM I would check with your ignition coil. The middle wire that goes from your distirbuter cap will lead you right to the ignition coil. It could be sparking on something metal around that area. Hope this helps, James Booth
My 2005 Silverado 4.3 starts
If no evidence of anything wrong with the codes your being told to check. It might be your ECM is bad, I had a friend had similar problems and they put a new ECM in it and it ran great again.
How to cut ABS light off on 2005 Chevy
i dont think you mean take the light out if you clean the eyes on the rotors and make sure none of the wires are cut disconnect the battery for 5 min then reconnect the battery and the light will go out. if you want to remove the bulb all you need is a Phillips screwdriver pull the dash out and remove the bulb good luck
My trans will not down shift and when you take off
Has the Powertrain Control Module (PCM) been tested for fault codes? if not get this done firs. This transmissions shifting is controlled by a computer via electric shift solenoids inside the transmission pan mounted to the valve body.
Headlights and dash lights flicker / pulsate one
Check for a loose ground wire(s). If you cant find a loose ground wire check the ground post on the battery. sometimes the ground post will break off inside the battery(especialy w/ the cheap junk they have for batteries now)Sometimes you can solve a ground or negative issue by running a secondary ground from the battery to say the firewall or frame. Make sure you clean off any paint and undercoating down to the bare metal at the point you are attaching the new ground to.once the ground is established put some light paint on the spot to keep out rust.
Not finding what you are looking for?