20 Most Recent 2005 Chevrolet Silverado 2500HD 2WD Questions & Answers

The impeller can fall off the water pump internally and it will not leak, but no coolant will circulate. If you need further help, reach me via phone at https://www.6ya.com/expert/jason_e95d2f9c1ac9610d

You have air in the fuel system, it takes special skill and tools to bled it properly.

http://www.pacificnorthwestspine.com/wp-content/uploads/2015/11/dodge-ram-Wiring-Diagram-For-7-Pin-Trailer-Plug-best-detail.jpg

Under the hood

Take it to autozone an have engine codes checked,could be computer malfunction.

Could be a bad door switch does the door ajar light stay on all the time or not come on at all?

You need to add BRAKE fluid. After that, blead your brakes. You need to find out where the brake fluid went. If there are no leaks, you need to check the remaining life on all four brake sets. If you have no leaks, chances are pretty good that you need new brakes.

there is a petcock at the bottom of the rad drain ti from there and use a antifreeze tester to check protection temp

flasher relay is bad
or bad bulb

It will be a diesel oil only, with a viscosity rating of 15w-30 or 20w-50 depending on the ambient temperature of your area. The brand is immaterial but it has to be diesel oil to have the ingredients needed to run a turbo. Oil used in a petrol engine will not be suitable for this application.

remove coolant ,remove hoses ,replace

why double post. its back up one. or add to it, dont make new posts same topic. thanks

alldata.com log in , read. first pull the battery neg lug first then when working on steering parts, do not damage the clock spring. read the FSM or alldata.com on all warnings on that $pring. do not forget to defeat the air bags first , do not guess, do read the fSm , it has like 1000 warning boxes in the book. after all dead customers can not buy overpriced new cars. treat bags as a loaded shot gun and WIN! every time.

Well, all rubber seals/components will have to be replaced this includes but not limited to calipers, master cylinder, wheel cylinders, ABS unit... and the system most be flushed. The used of petroleum based fluids is a no no cause the rubber components in the system are not compatible therefore causing the rubber to swell and the brake system to fail.