2004 Chevrolet Cobalt - Answered Questions & Fixed issues
2004 cobalt not reading correct speed
The speedo needle stepper motor is defective, remove the instrument cluster and send it out for repair. This is a common problem on this year of GM all models.
Chevy cobalt cranks but wont run above 10 mph
I doubt the security system would cause the problem.Most systems prevent the starter from working as well as the fuel pump or injectors.And once the starter cranks the engine it should not be involved.
I FOUND A SPRING IN MY WINDOW AT THE BOTTOM 2006 COBALT
I have seen a spring on the window regulator which helps raise the window. Don't know about GM products made in the past 10 yrs.You might look at a regulator at the dealer and see if it has one and if it looks like what you saw.
My engine light came on
TPS I assume
Get it fixed by a trained mechanic right away or you may have it towed away instead to repair
How do u remove the drivers side door panel to fix
YOU NEED CLIP REMOVAL TOOL TO REMOVE WINDOW CRANK HANDLE.YOU NEED DOOR PANEL FLAT TOOL REMOVE DOOR PANEL HATE TO SAY DOOR PANEL HAS AT LEAST 8 CLIPS LOCATIONS 4 CLIPS AT THE BOTTOM PANEL 2 CLIPS ON BOTH SIDES DOOR PANEL. YOU HAVE TO REMOVE 2 SCREWS HOLDING DOOR PULL CUP.YOU HAVE RELEASE CLIP BEHIND DOOR HANDLE USING TRIM TOOL.IF YOU HAVE TROUBLE GETTING DOOR PANEL OFF.HAYNES REPAIR MANUAL CAN HELP.
How do i remove 2008
- Raise and support the vehicle.
- Place a drain pan under the oil pan drain plug.
- Remove the oil pan drain plug.
- Drain the engine oil.
- Remove the engine belt
- Remove the lower AC compressor bolt.Remove the 4 oil pan to transaxle bolts (1).
- Remove the oil pan bolts.
2007 2.2l. Why is it stuck in Drive?
Sounds like electrical problem. Is the electrical connector properly connected to the valve body on the transmission ?
Maybe a solenoid was accidently unplugged when you had the cover off.
2006 LS. Where is harness to connect camshaft position sensor?
You really need to invest in manuals for these vehicles you're working on. I don't think this engine has a camshaft position sensor, regardless of the diagram you posted. Does the engine run? Is there a connector there to rewire? Is there a port/opening to insert a camshaft position sensor into? General Motors used the 2.2L and 2.4L ecotec engines in several models from 2002 to 2006 (or later) that had no camshaft position sensors.
Not finding what you are looking for?