20 Most Recent
1987 Chevrolet Blazer Questions & Answers
Car wont start, turns over fine but theres no feed of gas to carb
take your distributor cap off and check the ignition module for loose wires or even a ground strap thats connected to the engine to the body , you can take the module to autozone and have it checked for free, it might have a crank position sensor thats going wacky
I have two sending units on the housing for the oil filter and the top sending unit started leaking real bad. This is on my 1987 S-10 Blazer 4X4 with a 2.8 V-6
Well, first off would be to replace the faulty sending unit so that the oil pressure will stabilize. Second, if I'm reading this correctly that you have no oil in the oil filter at all? If not, your oil pump could be quitting or it did quit. It's recommended not to start the truck until it can be checked for oil pump operation. Have the valves been chattering badly? The only 3 things that would prevent oil from getting to the oil filter are a blocked passage, a failed oil pump or no oil in the motor at all. When the oil guage has that fluctuation is when the pump is going out or again the engine has no oil or a leak so massive that the guage can't hold a stable reading. Good luck
97 Blazer starts runs and goes a few feet and quits does restart
I had a similar problem with my 1994 Ford F-150. The truck would start and I could drive fine for about a mile or so and then it would cut off. After about an hour it would start again and do the same thing. I discovered that the coil was bad. However, you may have a coil pack on yours. Have your coil or coil pack checked.
87 blazer wiring schematic
GM fusible links are always 2 sizes smaller than the wire they are in, so I think you are looking for about size 14 wire, or you could buy new links and splice them in.
Not finding what you are looking for?